Mazda 626 owners have reported 7 problems related to cruise control (under the vehicle speed control category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Mazda 626 based on all problems reported for the 626.
Traveling in car on interstate in the right hand lane using cruise control set at 70mph. Was coming up on a car and tapped the brake to disengage cruise control and the car did not disengage. I tried to use the brake and it was not working and went to the floor. I could not shut the cruise control off at the controls on the steering wheel either. I quickly swerved onto the shoulder of the freeway to avoid hitting the car in front of me. My husband turned off the ignition and I eased up on the emergency brake and we came to a safe stop. After inspecting the car we turned the car back on and tested the brakes at slow speeds on the shoulder and the brakes engaged normally. My husband feels the cruise control stuck and that is why we could not stop the car with the cruise control buttons or with the brake pedal.
See
all problems of the 2001 Mazda 626
🔎.
Speed control would not disengage when applying brakes, and engine increased power, consumer turned onto median to prevent crashing, consumer turned ignition off and vehicle spun out causing vehicle to hit a ditch and damage the underside and 2 wheels. Dealer replaced loose brake light and cruise control switch.
See
all problems of the 2000 Mazda 626
🔎.
When driving the o/d off light flashes, the cruise control will cut off without touching the brakes. When accelerating from stops the engine revs but the car continues to move as though it is in neutral for about 5 to 10 minutes before it kicks in gear very hard. Occassionally the car will not even roll forward when trying to accelerate after stopping.
See
all problems of the 1996 Mazda 626
🔎.
Idle needed adjusted.
See
all problems of the 1997 Mazda 626
🔎.
Idle speed control failed.
Vehicle will stall with no warning. Checked vehicle, and had the idle speed control replaced. Vehicle then started idling at 2000 rpms, fluctuating. Diagnostic indicated need to replace power-train control module (pcm). Vehicle was not part of recall NHTSA campaign 97v228000 due to VIN. Please describe details.
See
all problems of the 1998 Mazda 626
🔎.
When traveling headlights are very dim, causing poor visibility. Also, cruise control does not work. Compressor on the air conditioning went out.
See
all problems of the 1999 Mazda 626
🔎.
| Problem Category | Number of Problems |
|---|---|
| Vehicle Speed Control problems | |
| Cruise Control problems | |
| Accelerator Pedal problems | |
| Car Accelerates On Its Own problems | |
| Speed Control Cable problems | |
| Speed Sensor problems |