Automatic Transmission Control Module problems of the 2018 Mazda MAZDA3

My 2018 Mazda 3 has an intermittent electrical failure on the high-speed can network that causes multiple safety-critical systems to fail while driving. When the fault occurs, the dash lights up with warnings for powertrain, abs/traction, lane departure, collision-avoidance, tpms, immobilizer, and the check-engine light. The car also hesitates or “lurches” between 15–30 mph during these events. At one point in 2024, the vehicle went into limp mode on the freeway, creating a safety hazard. These failures are intermittent but repeatable. Diagnostic scans from 2023–2025 show multiple u-codes for lost communication between control modules; two later became permanent. The issue appears unrelated to any one component and affects many systems at once. The vehicle has been to every Mazda dealership in the north texas region (mesquite, freeman, hiley, norm reeves, town north). All performed only basic scans; none completed a full can-bus or wiring-harness diagnostic. Town north kept the vehicle for six weeks (sept–oct 2025), replaced a coil and spark plugs, performed a camera calibration and a tcm update, but the network failures returned within 38 miles. We sought independent inspection only after dealerships repeatedly refused diagnosis whenever the warning lights were not on at the moment of arrival. In November 2025, a technician found significant internal corrosion inside the negative battery cable; touching the cable reproduced the full failure immediately. The corrosion extends deep into the wire sheathing. This appears to be an electrical defect affecting can communication and power/ground integrity. When the fault occurs, multiple safety systems disable at once and the vehicle behaves unpredictably. Mazda corporate has declined further assistance, and the defect remains unresolved. I am filing this report because this is a recurring safety issue that may affect other vehicles of the same model and year.