Body problems of the 1999 Mercedes Benz C280

Two problems related to body have been reported for the 1999 Mercedes Benz C280. The most recently reported issues are listed below.

1 Body problem

Failure Date: 07/30/2015

On July 30, 2015 around 1900 hrs. I was leaving home going to pick up my kids from around the corner. I came to a stop light (red). Begin to move forward when a loud bang happened then scraping. I got out the car to address the situation and observed that my vehicle was sagging. I retraced my tracks on foot and located my coil spring. Once I got back home, I jacked up the car and noticed my upper spring housing on my passenger side was broken.

2 Body problem

Failure Date: 12/09/2011

Tl- the contact owns a 1999 Mercedes Benz C280. The contact was driving approximately 35 mph over a bump and a loud popping noise emitted outside of the vehicle. The front end of the vehicle began to fall towards the ground and tilt to the right. The contact continued to drive with caution. The vehicle was taken to an authorized dealer where they detected excessive rust corrosion within the frame. A new spring perch and bushing will need to be welded to the frame; the technician advised the vehicle not be driven due to a safety hazard. The vehicle was not repaired. The manufacturer was not notified of the problem. The approximate failure mileage was 151,000. Rvk.




C280 Service Bulletins
C280 Defect Investigations