Mercedes Benz E320 owners have reported 3 problems related to brake abs warning light (under the service brakes category). The most recently reported issues are listed below.
The contact owns a 2004 Mercedes Benz E320. While driving at 75 mph, the brakes failed to respond and the abs warning light illuminated. The vehicle was towed, but was not diagnosed or repaired. The manufacturer was not notified of the failure. The approximate failure mileage was 131,000. The VIN was not available.
See
all problems of the 2004 Mercedes Benz E320
🔎.
Tl-the contact owns a 2005 Mercedes Benz E320. The contact stated that whhile driving approximately 60 mph, the abs warning light illuminated. The failure is recurring. The vehicle was taken to the dealer for diagnosis. The mechanic stated that the abs control module needed ti be replaced. The vehicle has not been repaired. The manufacturer was not notified manufacturer. The approximate failure mileage was 70,000. Kw.
See
all problems of the 2005 Mercedes Benz E320
🔎.
: the contact stated while driving 70 mph the abs indicator light illuminated continuously. The vehicle lost all braking ability. The vehicle was pulled off the road without incident using the emergency brake. The vehicle was towed to the dealership for inspection. The sbc pump was replaced. After a short period of time the abs indicator light illuminated again however; the brakes did not fail. The vehicle was taken to the dealer; the problem could not be duplicated. Now for the third time while driving 10 to 15 mph the abs indicator light illuminated continuously and the vehicle lost all braking ability. The vehicle was driven to the dealer and the sbc pump was replaced for the second time.
Problem Category | Number of Problems |
---|---|
Service Brakes problems | |
Brakes Failed problems | |
Brake Light On problems | |
Brake Electric Antilock problems | |
Brake Sensor problems | |
Brake Disc Pads problems | |
Abs Brake Fail problems | |
Brake Abs Warning Light problems | |
Brake Grinding Noise problems | |
Brake Hoses, Lines/piping, And Fittings problems |