38 problems related to car stall have been reported for the 2010 Mercury Milan. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2010 Mercury Milan based on all problems reported for the 2010 Milan.
The contact owns a 2010 Mercury Milan. The contact stated that while driving 65 mph, the vehicle stalled and the check engine warning lamp illuminated. The vehicle was taken to the dealer, who diagnosed the failure by resetting the power train control and changing the engine oil. The dealer stated no codes would show after running different diagnostic test. The vehicle was taken to the dealer on more than one occasion for the failure. The manufacturer was not notified. The failure mileage was 48,000 and the current mileage was 52,000.
While operating the vehicle under normal conditions the vehicle would stall out and lose power resulting in rapid decrease in speed and create unsafe driving situations. Car would still be running but pressing the gas would not result in acceleration. Turning vehicle off and restarting again would sometimes remedy problem but problem increased in frequency and severity, even happening to my wife while driving the vehicle on the highway at speeds in excess of 60+ mph traveling through bridge/tunnel system in local area.
The contact owns a 2010 Mercury Milan. The contact stated that while accelerating, the limp mode system engaged as the vehicle stalled. The contact took the vehicle to a local mechanic for a diagnostic test. The test results did not show any defect codes. The contact did not take the vehicle to a dealer for a diagnostic test. The failure mileage was 63,000.