Four problems related to front suspension control arm have been reported for the 1996 Mitsubishi Galant. The most recently reported issues are listed below.
I currently bought the 1996 Mitsubishi Galant for my wife and 11 month old daughter. The dealer told me I needed a front end alignment to get the pull and shake out of my front end. I took it to an alignment shop and the ase master tech. Told me my control arms were bent due to corrosion of the ball joint, he then told me there was a recall on these vehicles and if I don't get the problem fixed it could result in a loss of steering. I don't think it would be safe for my wife to lose steering with our infant daughter so now I got bigger problems then a twenty five dollar front end alignment. I'm upset at the dealer for not informing me with these recalls not the manufacture for making the bad part. Please help before it is too late.
Consumer had left front ball joint repaired under recall last year. 6 months later, right ball joint broke. Consumer had repaired it. On 9/14/02 left ball joint broke again while driving, causing wheel to fall off.
Recall received on ball joint, ball joint boot. Took car to dealership and the service department checked it and said it was ok on 7/28/00. On 9/4/00 the ball joint broke, causing the left front wheel to turn sideways and causing a crash.
While driving at 50 mph the ball joint came out of joint, causing the axle to break. A recall was received on the ball joints and the vehicle was taken in for inspection. The dealer passed the vehicle off, stating that the suspension and ball joints were ok. Now we are having a hard time getting both Mitsubishi and/or the dealer that passed it off to accept responsibility after another mechanic has since checked said it was caused by a faulty ball joint.