general problems of the 2010 Mitsubishi Outlander

Dealer wants to replace rear lower control arms due to corrosion and the car control arms were never addressed when I took it into the dealer for recall 16v458. The dealer was supposed to add a anti corrosion spray to the control arms in the front and back. The corrosion is very bad with these parts on my car and I am very concerned about safety.

High point Mitsubishi in high point nc preformed the recall in regards to rust forming on the underside crossmember of this vehicle. Less than 3 years later this vehicle is immovable because of the exact same reason as the original recall. The technician obviously overlooked areas of which to spray the rust preventative in which caused the structural integrity to completely fail at the front mounting location of the driver side control arm onto the crossmember. This vehicle is not safe to drive any longer because of Mitsubishi's lack of thoroughness in performing and evaluating the situation and the condition of said crossmember. High point Mitsubishi now insists that the issue was resolved even after clear pictures have been sent showing the clear damage and obvious nature of the reasoning of the recall in the first place but argue that they took care of the recall although obviously the exact issue that the recall was made for is thr reason this vehicle is no longer driveable.

The cross member is rusted through with holes in it. Dangerous to drive.