Car Stall problems of the 2006 Nissan Maxima

Bought car one year ago at 120000 miles. After 2 mos, car started jumping while pressing acceleration and then began to just stop while I was driving. Engine light came on , had camshaft position sensors replaced. Less than 2 mos later, car was starting to stall again, accelerator still making the car stall. Had fuel system checked, was fine. Then my engine light came on again, now saying camshaft position timing needs to be replaced. Mechanic told me this is the most common problem he sees in Nissan vehicles. Should be a recall on the timing chain if the problem is so common. I ran into a ditch twice and very nearly was in an accident when my car cut off while I was turning at a busy intersection. I couldn't turn the wheel and nearly crashed! this has happened numerous times. I reported the issue directly to Nissan but since no accident was reported I did not receive any help or advice from them.

The contact owns a 2006 Nissan Maxima. While attempting to start the vehicle, it failed to start. The contact stated that the vehicle would eventually start after several attempts. The contact stated that the vehicle would also jolt forward when switching gears and stall. The tcs engine slip indicator illuminated on the instrument panel. The vehicle was taken to the dealer, but was not diagnosed nor repaired. The manufacturer was made aware of the failure. The failure mileage was 115,000.

My car stalls and shuts off unexpected when at a stop, it also will not accelerate over 40 mph in traffic. I took it to a local auto store to test the (service engine soon) light, comes back with codes relating to the camshaft and crankshaft position sensors.

The contact owns a 2006 Nissan Maxima. While driving various speeds, the vehicle stalled without warning. The vehicle was not diagnosed or repaired. The manufacturer was notified of the failure. The failure mileage was 132,491. The VIN was not available.

My car will start off riding great but then the jerking starts and the acceleration stalls. I am so afraid that I may get in an accident as a result of the constant jerking. Sometimes my engine revs up and my car jerks as if the whole car will just fall apart. I pray everytime I get behind the wheel. I don't have $3,000 to get it repaired and I should not have to pay for it when there is a class action suit against Nissan for this issue. I am hoping that a recall is done so that I won't have to pay. I believe its a major safety issue because I can get in an accident or injure someone. It pisses me off that Nissan won't take responsibilithy.

While driving on the interstate, I had cruse control set at 80mph. There was a stalling/jerking motion that took place. After looking over the instrument panal. I notice it was still on cruse control but the mph had dropped a few miles. Once cruse controll was disengaged, I noticed the difference in acceleration. It felt like my car was stuck in third or forth gear. I had to hold pedal to the floor and wait as it picked up speed.

The contact owns a 2006 Nissan Maxima. While driving 20 mph, the vehicle suddenly pulled to the right and the contact crashed into the vehicle next to him. The contact's vehicle flipped over several times. She sustained injuries to her left arm. No one else was injured. A police report was filed. The vehicle is currently being diagnosed by the contact's insurance company. Prior to the crash, she noticed that the vehicle would stall while driving at any speed. The current and failure mileages were 38,500.