Tail Light Problems of Oldsmobile Cutlass

The contact owns a 1997 Oldsmobile Cutlass. When the brake pedal was depressed the tail lights failed to illuminate. The mechanic stated that there was failure in the circuit. Occasionally, it took approximately five minutes before the gears engaged when attempting to shift from park to reverse. Both failures have been occurring for two months. The current mileage was 208,627 and failure mileage was 205,583.

See all problems of the 1997 Oldsmobile Cutlass 🔎.

Description of problems- drivers side rear window replaced at delivery due to large scratch. Tail light cover replaced due to moisture build up. Drivers and passengers window motors replaced due to malfunction. Ball joints replaced at 2000 miles, cv joints replaced at 1000 miles, control arms replaced once at 5800 miles and again at 10000 miles. Steering rack replaced at 12400 miles, by this time the complete front end had been replaced from the factory original. And at 19000 miles it is making noise again.

Left & right park light and rear tail light holding moisture. Yh.

Turn signal switch short. No taillights when turn signal is on. One way both side taillights go out and the other way one side of taillights go out. When turn signals are not being used, sometimes I have tailights and sometimes I don't. They blink on and off. This has almost caused an accident and it started after I had my car in the dealer for the recall work on the driver side airbag. I have no taillights and I am concerned about my safety when driving my car. It is very unsafe to be driving without any taillights. The only lights that work on the back end of my car are the brake light in the window and the reverse lights. The rest of the lights go on and off.

See all problems of the 1996 Oldsmobile Cutlass 🔎.