Turn Signal Switch Problems of Oldsmobile Cutlass

Turn signal switch/multi function switch that also controls the cruise control, wipers, and windshield washer. 1. I can't put the turn signal lever in the locked position when signaling a right or left turn, the signals won't work. I have to apply just enough pressure on the lever to make the signals blink. 2. My emergency flashers won't work at all and I had to remove the upper part of the switch on the steering column because if you accidentally bump it the turn signals and brake lights won't work. 3. My windshield wipers will not work on low unless I turn on the left turn signal. When the left signal is blinking the wipers work perfect on low. When I turn the wipers on fast they will not work unless the left turn signal is on and then they go up three inches and down three inches.

Steering column turn switch failure caused rear brake lights to go out completely - total dark - this is very dangerous, and will cause a rear end collision! ! it is also hard to discover - that's why people don't use turn signals - they wear out early, and cost a lot! brake lights are major safety equipment!!.

See all problems of the 1996 Oldsmobile Cutlass 🔎.

Turn signal switch short. No taillights when turn signal is on. One way both side taillights go out and the other way one side of taillights go out. When turn signals are not being used, sometimes I have tailights and sometimes I don't. They blink on and off. This has almost caused an accident and it started after I had my car in the dealer for the recall work on the driver side airbag. I have no taillights and I am concerned about my safety when driving my car. It is very unsafe to be driving without any taillights. The only lights that work on the back end of my car are the brake light in the window and the reverse lights. The rest of the lights go on and off.

The turn signal switch failed.

Multifunction switch failed.

See all problems of the 1997 Oldsmobile Cutlass 🔎.