Front Suspension Wheel Bearing Problems of Oldsmobile Silhouette

Oldsmobile Silhouette owners have reported 8 problems related to front suspension wheel bearing (under the suspension category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Oldsmobile Silhouette based on all problems reported for the Silhouette.

1 Front Suspension Wheel Bearing problem of the 2003 Oldsmobile Silhouette

Failure Date: 05/18/2006

The contact owns a 2003 Oldsmobile Silhouette. The contact stated that the vehicle makes a clunking noise when the brakes are applied. The gm dealer diagnosed the vehicle as needing the front wheel bearings replaced. The VIN and purchase date were unknown. The current mileage is 66,000 and failure mileage was 65,000.

See all problems of the 2003 Oldsmobile Silhouette 🔎.

2 Front Suspension Wheel Bearing problem of the 2001 Oldsmobile Silhouette

Failure Date: 03/01/2006

Our 2001 Oldsmobile Silhouette has had numerous issues. The issues are placed in a close chronological order. All events have occurred after 50k miles with the exception of the power door locks. The dealer took care of all recalls. The power door locks intermittently lock and unlock. This problem has been to the dealer over 4 times. The first time the dealer replaced ignition switch wiring harness and the last time the dealer replaced a chafed wire under the passenger seat. The other times the dealer could not isolate. The problem still occurred. We got tired of bringing it to the dealer. The drivers side seat heater had failed. At 66k miles, the transmission went out. It was due to a faulty sun gear. I had to replace tie rods on the vehicle twice on each side. Once around 70k and once around 115k. The fuel ascending unit failed around 90k. On the passenger side I had to replace the wheel bearings and the cv axle. Lights in the heater controls have blown and the only way to replace them is to solder new bulbs onto the control module. The blower motor failed on 1st and 2nd speed. We experienced the same engine overheating issues as seen by other individuals at mycarstats. Com. This relates to the cooling system. I had three separate issues stemming from this. The first failure was a blown head gasket. About 8 months later the upper manifold gasket blew. Six months later another cooling system failure blamed on the lower intake manifold. Many of the repairs where costly. The lower intake manifold failure was never fixed. We decided to pass this gm piece of junk on. It had 137k miles. Most of the miles driven where highway, very few city and stop-and-go.

See all problems of the 2001 Oldsmobile Silhouette 🔎.

3 Front Suspension Wheel Bearing problem of the 2001 Oldsmobile Silhouette

Failure Date: 10/25/2005

Transmission failure-three times in as many years also electrical problems with rear lights and also intake manifold leaking. Both window switches failed. Passenger front wheel hub had to be replaced.

4 Front Suspension Wheel Bearing problem of the 2002 Oldsmobile Silhouette

Failure Date: 11/17/2004

While the vehicle was getting the tires rotated mechanic informed the consumer that both rear wheel bearings needed to be replaced.

See all problems of the 2002 Oldsmobile Silhouette 🔎.

5 Front Suspension Wheel Bearing problem of the 2002 Oldsmobile Silhouette

Failure Date: 12/16/2003

Awd disable and abs lights illuminated. Right front wheel bearing and hub assembly failed and were replaced.

6 Front Suspension Wheel Bearing problem of the 2002 Oldsmobile Silhouette

Failure Date: 04/30/2002

Awd disable and abs lights illuminated. Left front wheel bearing and hub assembly failed and was replaced.

7 Front Suspension Wheel Bearing problem of the 2001 Oldsmobile Silhouette

Failure Date: 03/15/2002

Third time into shop for low brake fluid warning light. Previously replaced wheel bearing and a sensor.

8 Front Suspension Wheel Bearing problem of the 2001 Oldsmobile Silhouette

Low brake fluid light comes on. 1st repair replaced wheel bearing(!), second repair - sensor. Third repair master cyl. 4th repair 2 calipers, 2 wheel cyl, 4 hoses (all rubber) mech reports rubber seems "attacked".


Other Common Suspension related problems of Oldsmobile Silhouette



Fuel Economy of Silhouette Vehicles
Silhouette Service Bulletins
Silhouette Safety Recalls
Silhouette Defect Investigations