Four problems related to suspension have been reported for the 2006 Subaru Forester. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2006 Subaru Forester based on all problems reported for the 2006 Forester.
Front drivers side control arm broke at bracket point and lost control of vehicle steering. And car was damaged hitting a post. Vehicle per recall for control arm had already been “fixed” contacted Subaru if control arms were replaced under recall or the “rust proofing” applied.
Front control arm failed on car. Which snapped the front axle and sway bar link on right side. Found out it was a known issue that was taken care of by dealer. Waiting to see if they will cover repairs.
The contact owns a 2006 Subaru Forester. The contact stated that upon purchase of the vehicle, he discovered that the vehicle was included in NHTSA campaign number: 11v464000 (suspension). The contact then took the vehicle a dealer where he was informed that the recall was serviced. Less than two months later, the contact stated that while driving 60 mph, the steering wheel began to shake as he began to lose control of the vehicle. There was no warning light illuminated. The contact used excessive force to steer the vehicle off to the highway shoulder. The contact inspected the vehicle and discovered that the front driver’s side lower control arm was fractured. The vehicle was towed to an independent mechanic where the contact discovered that no work was performed on the vehicle. The contact purchased the parts and replaced the control arm himself. The manufacturer was not notified of the failure. The vehicle was repaired. The failure mileage was approximately 189,000.
I was made a turn at roughly 15mph and the front passenger side control arm sheared in half causing me to lose control of the vehicle and then abruptly come to an immediate stop. My family was in the car and at a higher speed this could have been fatal. Had there been any vehicles behind me that could have caused an accident with unknown results. Had this been moments early I would have been in a head on collision. This is a known issue for this year, make, and model that was not properly resolved in the past by the manufacturer. The part should not fail in that manner. There were no warnings. The failure was inspected by the tow truck driver.