Front Air Bag Sensor Control problems of the 2016 Toyota Corolla

The contact owns a 2016 Toyota Corolla. The contact stated that her driver's side seat belt sensor was defective and activated while engaged. The vehicle was taken to Toyota chula vista (650 main st, chula vista, CA 91911) to be repaired under NHTSA campaign number: 20v024000 (air bags). Following the repair of the air bags, the failure recurred immediately upon using the seat belt. The contact then took the vehicle to valley hi Toyota (14612 valley center dr, victorville, CA 92395) where she was informed that she would have to pay a diagnostic fee to determine the failure. The manufacturer had not been notified of the failure. The vehicle had yet to be repaired. The failure mileage was approximately 7,000.

I checked my VIN number for recalls. Manufacturer recall number 20tb03, NHTSA recall number 20v024, dated: Jan 17, 2020 and read; �the subject vehicles may be equipped with an electronic control unit (ecu) from a specific supplier designed to receive signals from crash sensors and deploy the airbags and seat belt pretensioners. The ecu may not have adequate protection against certain electrical noise that can occur in certain crashes, such as severe underride crashes. This can lead to incomplete or nondeployment of the airbags and/or seat belt pretensioners. �.

I've a recall on my 2 Toyota Corolla 2015 and 2016, that came out on Jan 17 2020 and it has being more than 30 days and there's no remedy to the date . I do and my family not feel safe to drives those vehicles . What should I do on this case . ? please advice . A sensor from the air bags is not sending signal to the air bags in case it need to deploy, also the seat belts according with the information does not working properly .

It happened while it is the Toyota dealership and car was certified! they just updated the software disabling something and cover up like erasing the face of the problem instead of solving it. 01/17/2020 Toyota motor sales, USA, inc. Manufacturer safety recall issued NHTSA #20v024 recall #20ta03 safety recall 20ta03 (remedy notice) - multiple models and model years - incomplete or nondeployment of airbags and/or seat belt pretensioners may occur status: remedy available https://vinrcl. Safercar. Gov/VIN/vinlookup recalls results by VIN - vehicle identification number print share VIN: 5yfburhe7gp409680 year: 2016 make: Toyota model: Corolla number of open recalls: 1 NHTSA recall number: opens new window takes away from VIN lookup section>20v024recall date: January 17, 2020 manufacturer recall number: 20ta03 summary: the subject vehicles are equipped with an electronic control unit (ecu) from a specific supplier that is designed to receive signals from crash sensors and deploy the airbags and seat belt pretensioners. The ecu may not have adequate protection against certain electrical noise that can occur in certain crashes, such as severe underride crashes. This can lead to incomplete or nondeployment of the airbags and/or seat belt pretensioners. Safety risk: airbags and seat belt pretensioners that do not deploy as intended can increase the risk of injury in a crash. Remedy: any authorized Toyota dealer will install a noise filter between the airbag control module and its wire harness free of charge. Recall status: recall incomplete manufacturer notes: if the manufacturer has failed or is unable to remedy this safety recall for your vehicle in a timely manner, please contact the NHTSA vehicle safety hotline 1-888-327-4236 or tty: 1-800-424-9153 or file an online complaint with NHTSA.