Front Suspension Control Arm problems of the 2004 Toyota Sequoia

Two problems related to front suspension control arm have been reported for the 2004 Toyota Sequoia. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2004 Toyota Sequoia based on all problems reported for the 2004 Sequoia.

1 Front Suspension Control Arm problem

Failure Date: 11/01/2016

Frame is rusting underneayh to the point where I have had to repair the vehicle control arm which rusted off and broke while driving. My tow hitch mount has rusted off. There are more than 5 spots along the frame where rust has perforated and the frame has visible signs of rot. I had a licensed garage inspect the frame and was told the vehicle is dangerous and that the frame should be replaced. I am having continuous problems with the suspension components rusting out.

2 Front Suspension Control Arm problem

Failure Date: 04/30/2015

Made a left hand turn and the control arm broke off from rusted frame while traveling at about ten mph. Repair center say's the vehicle is a total loss, because the frame is not safe, nothing to re-attach control arm to!.




Safety Ratings of Sequoia Cars
Fuel Economy of Sequoia Vehicles
Sequoia Service Bulletins
Sequoia Safety Recalls
Sequoia Defect Investigations