Tank Assembly problems of the 2004 Toyota Sequoia

Three problems related to tank assembly have been reported for the 2004 Toyota Sequoia. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2004 Toyota Sequoia based on all problems reported for the 2004 Sequoia.

1 Tank Assembly problem

Failure Date: 02/23/2010

Excessive rusting under the truck, including the axle, brake areas and gas tank.

2 Tank Assembly problem

Failure Date: 06/17/2009

I have a 2004 Toyota Sequoia. Over the last two years the gas needle, on occasion fails to register the true level of gas in the tank. When I start the car, the needle reflects the tank is empty and the gas empty light is on. It takes approximately 10-15 minutes to correct. The first time it happened I immediately stopped to fill the gas tank. It took less than three dollars to top off the tank. After topping off, it still showed the tank was empty for at least 10 to 15 minutes. The latest incident was in June 2009.

3 Tank Assembly problem

Failure Date: 05/10/2005

Fuel gauge indicate empty, when tank is full.


Other Gasoline Fuel System related problems of the 2004 Toyota Sequoia

Tank Assembly problems
3
Gasoline Fuel System problems
2


Safety Ratings of Sequoia Cars
Fuel Economy of Sequoia Vehicles
Sequoia Service Bulletins
Sequoia Safety Recalls
Sequoia Defect Investigations