Suspension Related Problems of the 2008 Toyota Sequoia

Table 1 shows two common suspension related problems of the 2008 Toyota Sequoia. The number one most common problem is related to the suspension (four problems). The second most common problem is related to the front suspension control arm (one problem).

Table 1. Suspension related problems of Toyota Sequoia

Problem Category Number of Problems
Suspension problems
4
Front Suspension Control Arm problems
1

Recently reported Suspension problems of the 2008 Toyota Sequoia

The Suspension problem

My wife pulled out of a parking lot and there was a loud noise and the vehicle began to shudder violently. Approximate speed was 10 mikes an hour and she was able to stop. The drivers side rear suspension airbag had broken through the lower control arm, and was under the rear driver side tire.   Read details...

The Front Suspension Control Arm problem

Found a large (2" dia. ) washer on the driveway at rear of the car and later a large approx. 3/4" bolt head on the driveway at the front of the car. Upon inspection of the underside of the vehicle, noted that the front bolt on the right rear control arm was missing its head.   Read details...


Suspension related problems in other Toyota Sequoia model year vehicles:



Safety Ratings of Sequoia Cars
Fuel Economy of Sequoia Vehicles
Sequoia Service Bulletins
Sequoia Safety Recalls
Sequoia Defect Investigations