Toyota Sequoia owners have reported 493 structure related problems since 1996. Table 1 shows the 15 most common structure problems. The number one most common problem is related to the vehicle's body (201 problems). The second most common problem is related to the vehicle's frame rust (140 problems). For details of each of the problem category, use the links in the table.
My 2003 Sequoia was in the garage for a check on the brakes. I also asked them to check the frame for any rust issues, because I had previously been concerned about it earlier. They reported to me that the car should be off the road because the rust in the frame was so severe. Read details...
2007 Toyota Sequoia. Consumer writes in regards to rusted frame on vehicle. The consumer stated there was a recall for the rusted frame, but was never made aware of it. The consumer was advised a notice was sent. The consumer claimed to not have received the letter. Read details...
The contact owns a 2003 Toyota Sequoia. While driving approximately 45 mph over a bump in the road, a rattling noise was heard underneath the vehicle. The contact continued to drive the vehicle to work. Read details...
The contact owns a 2004 Toyota Sequoia. The contact stated that while completing an inspection and emissions test on the vehicle, the mechanic informed the contact that there was severe rust on the rear subframe of the vehicle, near the control arm, and several other areas on the subframe. Read details...
See attached document for complaint. Read details...