Steering Tie Rod Assembly problems of the 2004 Toyota Sienna

One problem related to steering tie rod assembly has been reported for the 2004 Toyota Sienna. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2004 Toyota Sienna based on all problems reported for the 2004 Sienna.

1 Steering Tie Rod Assembly problem

Failure Date: 12/15/2010

The contact owns a 2004 Toyota Sienna. While driving approximately 30 mph, the contact stated that the steering wheel became difficult to steer and the wheel would not return to the standard position when making a turn. The contact stated that the failure occurred when the weather was cold and usually when the vehicle was operated before given a chance to warm up. The vehicle was taken to an independent mechanic who advised that the stabilizer link was corroded. The steering rack and pinion, steering gear and linkage outer tie rods were also replaced. The mechanic also added power steering fluid but to no avail. The failure persisted and the contact returned to the mechanic for further diagnostic testing. The manufacturer was contacted and advised that there was a technical service bulletin for the failure under NHTSA item number: 10020994 (steering). The vehicle was not repaired. The approximate failure mileage was 90,000.




Safety Ratings of Sienna Cars
Fuel Economy of Sienna Vehicles
Sienna Service Bulletins
Sienna Safety Recalls
Sienna Defect Investigations