general problems of the 2006 Toyota Sienna - part 1

The tpms system failed in the ecm or engine computer. It uses the wheel speed sensors on each hub to measure differences in wheel speed and uses this to infer if any one wheel has low tire pressure. (this vehicle does not have tpms sensors in the wheels. ) however, with this failure, it reports a tire pressure problem even though all 4 tires are inflated properly. This problem persists even after cleaning then replacing wheel speed sensors. The problem appears to be in the ecm or engine computer, which is very difficult and expensive to replace. With this problem, the driver is never able to tell if any tire actually has low pressure because the system always reports that a tire has low pressure. Toyota should be required to fix this issue in all affected vehicles.

The slip indicator light (car with swerve lines) started coming on intermittently while turning on highways etc. (but not when any risk of tire slipping). Then vsc light also came on and alarm sometimes sounded. Visit to our own mechanic, no problems found. In the last 2 years the abs system has activated (daily) it unexpectedly applies the brakes while in motion. It is on specific types of curve and while driving at least 30mph, but has done at 35, 55, 70 mph, on slight or medium turns (not real sharp turns), going uphill or downhill and left or right. Took my mechanic for a ride with the diagnostic computer hooked up, it did the abs braking, warning light, and beeping 5 times but computer showed no codes. Suggested resetting yaw which we did, it did not help. Suggested calling Toyota, they were no help, said they had never heard of that problem and my mechanic probably did not know how to read the computer. When abs activates it's very dangerous - thinking about deactivating entire vsc system. I believe the rack and pinion may play a role, there are rattle and bump sounds, perhaps a loose suspension is the culprit, that is our next option. I have already replaced struts, front wheel bearings, all new tires, had it aligned, did new brake pads, and rotors. Absolutely fed up with this problem!.

Swollen lug nuts. Won’t fit any wrench. Affects ability to remove a tire in case of needing to repair a flat tire.

Check engine light, vsc light, traction control light. All 3 lights came on at same time. They say it's the gas cap, it's not the gas cap, they say to reset it, that doesn't work. I was driving home, nothing happened, the lights just came on. No warning sound, nothing to indicate there was a problem, my car seems to drive just fine, but the lights won't go off, and I have 3 kids that I take and pick up from school.

Tl the contact owns a 2006 Toyota Sienna. Whenever the contact parked the vehicle and attempted to turn it off, the key would fall out of the ignition. The contact stated that the vehicle was included in NHTSA campaign numbers: 17v657000 (power train) and 14v273000 (tires). There were no warning indicators illuminated. The dealer was not contacted. The vehicle was not diagnosed or repaired. The manufacturer was made aware of the failure and provided no assistance. The failure mileage was 177,000.

The contact owns a 2006 Toyota Sienna. The contact received notification of NHTSA campaign number: 14v273000 (tires) however, the part for the recall repair was unavailable. The contact stated the manufacturer exceeded a reasonable amount of time for the recall repair. The contact stated that when experiencing a flat and looking to place the spare tire on the vehicle they noticed the cable assembly for the spare tire was rusted causing the spare tire to become unable to be used. The contact informed the dealer of the failure and the contact was informed that there were no parts available for the recall. The dealer informed the contact that NHTSA was responsible for distributing the recall parts and that the NHTSA hotline should be contacted. The manufacturer was not made aware of the failure. The failure mileage was not available. Parts distribution disconnect.

Corrosion on oem 17' aluminum wheel rims caused air to slowly leak out between rim & tire. Leaking occurred over several days while vehicle was parked or being driven. Tires were re-mounted three times to correct problem. Tire shop had to clean & then polish rim mating surface to remove corrosion to get tires to seat & hold air.

Our vehicle has 119,698 miles of wear. We had our vehicle serviced at a reputable dealer. While stationary, both a wheel stud (during tire rotation), and the oil pump tensioner bolt hole (during service) broke. Dealer told us excessive force was not used. I believe inferior metal used in manufacturing.

Have an 2006 Toyota Sienna with 17" factory original alloy aluminum wheels and all 4 wheels have their protective coatings bubbling up from underneath and peeling off. Even though the van is nearly 9 years old now, it only has 72000 miles on it. But even so, it has had the bubbling up coating issue for 4 or 5 years already according to the last owner I bought it from. Looks to be a common problem with Toyota Siennas with the 17" alloy wheels in the area here in the upper midwest as most I've seen have the same problem. Concerned that the now exposed metal will corrode quickly and then at some point develop into a safety concern. This van is a heavy vehicle compared to regular cars on the road so I would think problems would arise quickly if there were a weakness to develop in the corroding metals. I'm currently experiencing air loss in only 1 tire/wheel. A local tire shop finds no leaks in the tire or valve stem and has tried dressing the beads with sealant. They think when the weight of the van is on the tire/wheel it's then leaking air out somewhere. Local Toyota dealer told me Toyota has no information on addressing my particular problem let alone recognize or state to customers that there is any kind of known repeating pattern of failure of the finish on the wheels on newer vehicles made in the last 10 yrs.

I want to know why Toyota is dragging their feet getting the spare tire bracket and cable corrected. I will not have my wife and daighter without a means to replace a flat tire when they are traveling. The fix is simple new mechanism with stainless steel cable and associated hardware. The offer to remove the tire and place that in the trunk is an insult as is not to carry it and call Toyota if they have a flat. This recall has been in place for a very long time and something has to be done. Recall is 14v273000.

All four alloy wheels on this vehicle have the paint bubbling and chipping off leaving the wheel exterior exposed to weather and further corrosion. Underneath the chipped paint the alloy is corroding, potentially compromising the strength and overall integraty of the wheels. I have experienced air loss in both front tires over the course of just a few days. My local tire shop checked both front tires for punctures but found nothing. They then removed the tires from the rims and indicated the rims had corroded around the outer diameter of the rim where the tire bead is supposed to seal. They cleaned the corrosion from the rim interior and applied a bead sealing compound that fills in the corroded and pitted bead area of the rim allowing the tire bead to seal and hold air. When it comes time to rotate the tires the tech person indicated that I should also have them seal the tires placed on the front of the vehicle as they would probably start loosing air as well with the added weight of the front wheel drive engine and transmission. This seems to be a common issue with this year model of the Toyota Sienna. Thus far,Toyota will not do anything to correct this issue which seems to me to be a serious safety hazard.

The contact owns a 2006 Toyota Sienna. The contact received notification of the NHTSA campaign number: 14v273000 (tires) however, the part needed to do the repair was unavailable. The contact stated that the manufacturer exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure.

Recently purchase this van and it has severe corrosion on the aluminum wheels and air seems to be slowly leaking from at least one of them. This could be a serious problem if it accelerates as one travels down the road.

I was sent a recall notice by Toyota, indicating that the "spare tire assembly may corrode and detach". I took my vehicle to the dealer on December 19, 2014, and they removed the spare tire and placed it in the vehicle in a plastic bag. They did not fix it properly. The spare tire is now occupying a lot of space that I need for cargo. They told me I would receive a letter when the proper remedy was available. I called Toyota this morning (may 21, 2015) after waiting five months for the letter. The Toyota representative that I spoke with said that the parts would become available for the remedy "in the middle of this year" but she could not even give me the month in which this would happen. I think it is too much to have to carry my spare tire around in my cargo space for several months. Toyota should have been able to solve this problem faster. This is not the vehicle's drive train. This is a metal hanger for a spare tire, it shouldn't be that difficult.

Tl-the contact owns a 2006 Toyota Sienna. The contact received notification of NHTSA campaign number: 14v273000 (tires) however, the part to do the repair was unavailable. The contact stated that the manufacturer exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. Ddr.

Tl- the contact owns a 2006 Toyota Sienna. The contact received a notification for recall NHTSA campaign number: 14v273000 (wheels). However, the part needed to do the repair was unavailable. The contact stated that the manufacturer exceeded a reasonable amount of time for the repair. The manufacturer was made aware of the issue. The contact had not experienced the failure. Pam.

The contact owns a 2006 Toyota Sienna. The contact received notification of NHTSA campaign number: 14v273000 (wheels). The dealer was unable to supply the part from the manufacturer for several months. The contact was unable to determine when the vehicle would be repaired. The contact had not experienced a failure.

Tl- the contact owns a 2006 Toyota Sienna. The contact stated that NHTSA campaign number: 14v273000 (tires) had exceeded a reasonable amount of time for repair. The dealer stated that a remedy had not yet been designed to deter this problem. The manufacturer was made aware of the delay. The dealer cut the spare tire cable without the contact's consent and placed the spare in the contacts truck. The vehicle was not repaired. The failure had not occurred to the contact. Az.

The contact owns a 2006 Toyota Sienna. The contact received notification of NHTSA campaign number: 14v273000 (wheels); however, the part needed to do the repair was unavailable. The contact stated that the manufacturer exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure.

The contact owns a 2006 Toyota Sienna. The contact received notification of NHTSA campaign number: 14v273000 (wheels) however, the part needed to do the repair was unavailable. The contact stated that the manufacturer exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. ## VIN passed ## Toyota Sienna 2006 ##.

Toyota Sienna recall for spare tire carrier moved the spare tire to the luggage compartment of vehicle. The tire was removed from the underside of the vehicle, placed in a bag, and placed in the luggage compartment. The tire was not secured by service and is free to vibrate, shake, and roll when turning. This was to be a temporary fix, with the permanent solution to be determined by Toyota. It has been over 6 months from the release date of the recall and there is still no permanent solution, and there is no eta for a fix at this time, per the Toyota customer service center. This issue needs to be resolved as it is limiting the available luggage compartment space, and the mvovement of the unsecured spare tire is distracting. What requirements are there for closing out action items on recalls and for completing "permanent" fixes?.

The vehicle has been 'grumbling' for the past few months. Finally took it in and they are having to replace the front wheel bearings. I don't think the bearings should be wearing out in just 100k miles.

All four wheels have severe bubbling and peeling paint. Since purchasing the car, I have always gone to the Toyota dealer for work and they have not paid any attention to this complaint. When I decided to have some work done with my husband's mechanic he raised the issue. He is concerned with the rust that is occurring and will continue to occur over time will eventually effect our ability to place new tires on the car as the rust encroaches into the rims.

Spare tire underneath the van fell on road while driving while I was driving into a mall. Called Toyota customer service at 18003314331 about this issue. Although Toyota has acknowledged this problem and issued a warning, they refused to fix this issue. If this had happened on a highway, there could have been serious consequences.

Run-flat tire went flat without the warning light activation. When it activated, there was already a hole in the tire from running it flat. The second time this happened, which was one week later, there was a hole before the light came on. The tire pressure is checked regularly on this vehicle.

I have had problems with my 2006 Toyota Sienna with most recently the power passenger sliding door that is broken and does not open or close. The dealer ft. Myers Toyota said the parts were on national back order and may take months to get the parts to fix. They did say they would cover under warranty. Secondly, my steering assembly needed replacement at 80,000 miles because of leaking fluid and I had to pay the labor to fix. Lastly, all 4 of the tire rims on the car have peeling, bubbling and chipping paint that is exposing the metal rim. It may cause further corrosion to the rims and cause a safety problem to the wheels. Germain Toyota in naples, fla where I bought the car would not help with the rims. Ft. Myers Toyota where I get the car serviced told me about the national back order problem and also charged me for the defective steering assembly which I thought should have been covered under their lifetime power train warranty. They said it did not.

All four wheels show excessive corrosion. Toyota says this is normal and not covered by any recall or warranty. Corrosion may be simply cosmetic, but our concern is that it will become structural over time causing either wheel failure or loss of tire pressure. See photos.

2006 Toyota Sienna xle limited premium alloy wheels with excessive corrosion under the paint causing the paint to blister and come off.

Wheels are corroding excessively, this may cause air leaks in the future. It is a 2006 with 74700 miles, this seems to me to be too soon for this kind of wear.

Chrome finish on wheels is bubbling and peeling off.

Wheel rims on 2006 Sienna are deteriorating with bubbling of alloy wheels appearing on rims. Bubbling is occurring throughout wheels and not in one area.

All 4 wheels on my Sienna have their plating peeling off and possibly subjecting the wheels to rust and deterioration. I keep my wheels clean and, while cleaning them recently, I noticed what I feel may be rusting where the plating is peeling. I mentioned this when I had my car inspected and also registered a complaint with Toyota corporation.

I have a 2006 Toyota Sienna. All four wheels are showing bubbling paint and are loosing tire pressure.

Corrosion on wheels of Toyota Sienna. Toyota is aware of the defect and refuses to replace the wheels.

I have a 2006 Toyota Sienna xle fwd. The alloy is flaking off my 17 " wheel rims. This is causing corrosion of the wheel which will eventually lead to failure. There are numerous complaints on this and Toyota is not taking corrective action.