Transmission Solenoid problems of the 2007 Toyota Sienna

I am the second owner of the vehicle. I was driving on interstate 5 at 65 miles per hours from sacramento to los angeles. The time was 1600 on 13 April 2014. I did not notice any crack or noise from road debris damage while I am diving. The red low oil warning light on the dashboard did not turn on at the time when the incident happened. I was pulled over a rest stop to use restroom; I also walk around the vehicle to conduct a visual check and fluid check at the same time. I was discovered engine oil was all over the engine bay, undercarriage and the back lift door during the visual check. When I checked the engine oil, the dip stick showed no engine oil. Again, the red low oil warning light did not turn on which indicate low engine oil at that time even the engine had no engine oil. Vehicle was towed to Toyota dealership and discovered an oil cooler hose which make out of rubber was ruptured. Even the oil cooler hose was replaced with a metal oil hose; the engine was damaged by operated without engine oil for a significant period. Prior to the trip, I purchased the all metal vvt-I hose from a local dealership, again no warning from the dealership. I used a local repair shop to replace the vvt-I hose locate at the passage side of the engine to an all metal pipe since I have knowledge on the rubber vvt-I hose have the same rupture issue. However, I have no knowledge on the t-sb-0201-11 which is the Toyota technical service bulletin title oil cooler pipe seep. There is recall regarding shift lock solenoid and severe corrosion of the spare tire carrier cable on the 2007 Sienna, however, there is no recall on possible rupture on vvt-I hose or oil cooler hose. If the recall was issued or at least warned by dealership, I will fix the oil cooler hose at the dealer or a local repair shop and avoid the engine damage which leaded to engine replacement.