general problems of the 2009 Toyota Tacoma

Brake failure because of rusted brake lines.

Brake failure resulting from rusted brake lines. Vehicle has not been inspected by manufacturer police or any other entity. No warning lamps or other indicators that detected brake failure.

I bought this vehicle used from a dealer in Jan second with 155185 miles I let the dealer know about the brakes were to hard we bought the truck and on Thursday 1/12/17 my wife took the truck to work that evening after getting home she told me that the brake pedal went to the floor so I took it to my repair shop on 1/13/17 to check it out they put the computer on to see what was going on they told me it was the abs unit I also lost the brakes taking it to the repair shop had to pull off the road than went real slow and pulled it into their shop also there was no warranty with the truck the warranty they had was to high so now its going to cost me over 3000 dollars cause the whole unit must replaced I just needed to know and you know if there was any other complaints or problems with that year and model I have had 6 Toyota vehicles and never had this to happen thank you OH yes this was on a city road going straight and in motion.

Today, 04/12/14, at around 11:55 a. M. , I had my fourth experience of unintended acceleration in my 2009 Toyota Tacoma. The first two incidents I had not reported. The third incident I did report to Toyota, they examined my truck and found nothing they thought would cause the acceleration. Today, I was approaching a busy intersection during a street festival in the downtown section of my home town. My truck did not stop when I pressed the brake, but the engine revved and the tires squealed twice as I tried unsuccessfully to stop the vehicle. It carried me through the intersection - if it had been occupied, I don't know if I would have been able to steer away from pedestrians, as the street was narrow and it all happened very fast. As soon as I had control of the truck, I pulled over to check the rug. The rug was hooked into its hole, a good 3 inches from the accelerator, and could not be moved by hand. I am now afraid to drive my truck, and am grateful to god that no one was hurt or killed. I had a passenger with me who witnessed this.

I was coming into a right handed corner on dry pavement doing 45mph (less than the suggested speed for the corner). As I let off the throttle and turned into the corner the vehicles stability control kicked in causing the truck to go straight. I had to fight aginst the steering wheel and managed to overpower the stability control but by then I was in the on-comming lane.

When changing direction of travel such as forward to reverse the brakes make a loud clank. Took to dealership multiple times and they stated the brake pad pins are actually hitting the rotors, that this is a known issue and there is no fix yet. My concern if there is no fix then how long will it take for these small pins to break causing me to loose critical breaking. The breaking system is one of the most critical parts of an automobile and I have kids in my vehicle. Why is this not a major concern to Toyota?.

Tl- the contact owns a 2009 Toyota Tacoma. The contact stated that the brake pedal became spongy, causing an increase in stopping distance. In addition, the contact stated that the accelerator and brake pedals were too close in proximity and was causing the contact to erroneously depress the accelerator pedal when attempting to engage the brake pedal. The vehicle was taken to the dealer however, the technician did not offer any assistance since the vehicle was performing as designed. The manufacturer was not made aware of the failure. The vehicle was not repaired. The failure mileage was 5 and the current mileage was 2,800. Kmj.

The contact owns a 2009 Toyota Tacoma. The contact stated that while driving approximately 40 mph around a curve, the abs engaged without the brakes being depressed. The electronic stability control warning indicator illuminated with a chime and then turned off. The failure recurred nine times. The vehicle had not been diagnosed or repaired. The manufacturer was not notified of the defect. The approximate failure mileage was 19,000. The VIN was unavailable.

I started my truck, outside temperature 22, pulled it into my garage and pressed on the brake to ease forward and the truck would not stop. I pressed as hard as I could on the brake but the truck continued forward and hit the front wall of the garage. It felt like it was trying to continue driving forward against the garage wall. I placed it into park and after calming down backed it off the wall.

Brake pedal goes all the way to the floor sometimes. If you pump it then it is ok.

This vehicle has what I consider to be a break problem. The pressure and length of pedal depression required to stop the vehicle is dangerous. I have to depress the pedal to the floor in order to stop under average driving conditions. It actually feels as though the pedal has not fully engaged the braking system when completely depressed. The length of travel in the pedal from the point where breaks initially engage and completely stops is excessive and could cause an accident. I have taken the vehicle in to Toyota for service and they have indicated that the breaks are within Toyota specifications and do not require service.

A some times low brake pedal, never takes hold at the same hight. Some times as high as just a 1/2 inch. The next time below the throtle by an inch. I have hit a pick up in the rear and a boulder. The dealer told me this is normal. Who do I belive.

Hi and low brake pedal, hard to tell how to stop and have ran it a bolder and a pickup with small damage.

Purchased new Toyota Tacoma trd sport in Aug 2009 with zero miles. All seemed ok, other than a few frustrating cab rattles here and there. However, I also noticed that as my truck neared more miles (7,000 current), I now have to press on the brake pedal a bit harder, yet when I brought this up to the dealer, they stated all was normal and could not replicate. I've had a couple of instances where I've had to press the brake pretty hard to come to a stop or slow down. It seems I need to ride it a little harder than when I first bought my truck. I also want to add, that besides the irritating rattles (door panels/tray holder in center console below the steering wheel - which was replaced, but still make pop sounds here and there, the other smaller rattles - some of which were coming from ill-fit window seals were not really fixed. The dealer replaced the seals and the popping sounds stopped for a day or so then returned. I found the problem is the seals tend to be somewhat improper fit. In other words, they are too large and cause the rubbing. I personally corrected this by removing all door panels only to find out that some of the rattle sounds I had complained about merely had a small piece of felt on the backside, which did not completely cure the problem. I purchased an entire roll of this material myself and coated the inside of each door panel then added a small piece of weather stripping to the inside of door panel edge where it touches the glass window. This helped considerably in reducing air noise and no more rattling. My complaint is still with the brake pedal sometimes, not always, needing to be pushed harder than normal to come to stop or slow down. On other thing I addressed with the dealer was the fact that when I slow down and make turn, not complete stop and go, my engine rpm's don't decelerate quickly enough for the transmission to catch up. Dealer states this is normal operating rpms catching down to shift down of tranny.

The contact owns 2009 Toyota Tacoma. The contact was driving approximately 20 mph on snow covered road conditions; proceeding to make a turn. The driver applied pressure to the brake system. The vehicle began to skid and steered into one direction uncontrollably. The vehicle bounced off a curb. The driver was able to gain control and resumed normal operation. There was a one time failure occurrence. The failure mileage was 27,000.

Brake pedal goes to the floor with out stopping, had it to the dealer three times with out a permanent fix.

Brake pedal low or high some times , what ever it feels like. Been in to fisher Toyota four times with no lasting fix, last time the factory rep said that this is standard and no trouble. I have all most wrecked more then one time as you never know how hard to push down to stop.

The contact owns a 2009 Toyota Tacoma. When he attempted to apply the brakes, the brake pedal would become stiff. This condition caused him to increase his stopping distances. On one occasion the brake pedal fell to the floor, which disabled him from pushing the pedal. The vehicle was taken to the dealership for inspection. The technician could not provide a remedy because he could not duplicate the failure. The current and failure mileages were 55000.

The brakes on my 2009 Toyota double cab are very spongy and down right scary. After several minutes of driving the brakes become very soft, the height of the pedal decreases and the vehicle pulls to the left or right before it finally comes to a resting stop. The vehicle stops only when the brake pedal is pushed inches away from the floor. The vehicle is very difficult to stop when loaded with cargo or traveling down hill. Sometimes when the vehicle is stopped it lunges forward even when the brakes are applied. I've been in law enforcement for 15 years or more which has allowed me to participate in numerous driving courses. I've also been driving since the age of sixteen,during that time I've owned many cars and trucks including Toyota. My Tacoma has the worse brakes of any vehicle I have ever driven. My driving experience has allowed me to avoid numerous accidents that my Tacoma has presented. I'm afraid my Tacoma will present me with a situation in which my skills want matter.

I have a 2009 Toyota Tacoma double cab pre runner. The brakes are spongy and become even softer when driven. The brake pedal slowly loses height, sinking towards the floor. Stopping distance becomes unpredictable and the vehicle becomes more difficult to stop. I've complained to the dealer several times, and filed numerous complaints with you guys. Will you please help me resolve my braking issue.

I own a 2009 Toyota Tacoma pre runner double cab. The brakes are very soft and become softer when driven. They only catch when pushed all the way to the floor. I'm very cautious when I drive the vehicle, spending most of my time judging distance. I'm afraid this method used to operate this vehicle will fail me soon.

The contact owns a 2009 Toyota Tacoma. The contact stated that when depressing the brake pedal, it would feel spongy and would not engage fully. The approximate failure mileage was 15 mph. The brakes would fall on the floor board. In order to get the brakes to engage, he had to pump the brake pedal several times. The dealer could not locate any failures in the braking system. The dealer stated that the brakes were operating as designed and the contact would have to get comfortable with the braking system. The manufacturer was not contacted. The failure mileage was 8,000 and the current mileage was unknown.

I notice the brake pedal goes all the way down before the brake feels that is applied. I've taken back to dealership and they found nothing in error. I disagree. I've had several other people drive my car-with the same concern. Brakes don't grab. My brother who is ups head mechanic said the same, a fault with the brake pedal. Shouldn't have to go to the floor before the braking system is applied. Just want you to know there's a problem there. I'm aware of it so I drive with caution. But this needs to be address. Thanks, patti kay. I took back to dealership oct. 22 2008 and they said the cause was from the floor mat---it doesn't matter how many floor mats you have it's in the pedal. Either needs adjusted or new pedal system put in.

S10 appropriate-letter from re concerns about the brake pedal in his 2009 Toyota Tacoma pickup truck. The consumer stated he noticed the brake pedal almost went to the floor board. The vehicle was taken to the dealer for an inspection, but they were unable to find anything wrong it.