Table 1 shows one common vehicle speed control related problems of the 2016 BMW 528.
| Problem Category | Number of Problems |
|---|---|
| Vehicle Speed Control problems |
A critical component failure has rendered my 2016 BMW 528xi inoperable and unsafe. The water pump failed, forcing the car into a safety "limp mode," limiting its speed to approximately 40 miles per hour. This issue mirrors NHTSA recall 24v-608 regarding an electrical connector on the water pump that can short circuit, potentially causing a "thermal event or fire. " the problem began with dashboard warnings about overheating, despite the coolant reservoir being full. Following these warnings, the vehicle entered "limp mode," posing a significant safety risk in normal traffic. The potential for fire is also a major concern. An independent service center has confirmed the water pump and its electrical connector as the point of failure. The failed component is available for inspection by a NHTSA investigator. I contacted BMW's customer relations line and was informed that no remedy is currently available. I must wait for an official letter before any action can be taken, including reimbursement. The representative did not provide a case number, making it impossible to track my complaint. The vehicle has not been inspected by the manufacturer, law enforcement, or an insurance representative. I am unable to transfer the title because the car cannot pass a safety inspection in its current state. I am in a severe catch-I must receive a recall letter for a vehicle that I am unable to finalize ownership of. This failure to assist an owner with a known safety recall has left me stranded with a dangerous, undrivable vehicle.
Coolant pump failure engine failure also caused fire in engine bay. Insurance inspector. Pre shop inspection. No light were on prior to explosion.