Car Stall Problems of BMW 650

Prior to 4/3/2018 on approximately 4 different occasions, the vehicle started and idled rough. Engine was turned off and re-started and ran smooth. On 4/3/2018 the vehicle stalled while driving and in traffic and would not restart. All engine power was lost (no power steering, no forward motion) but all electrical functions were ok. Towed car to BMW dealer where they found (2) high pressure and (1) low pressure fuel pump failures which were replaced under extended warranty. No other issues were discovered through the inspection and repairs. On 5/22/2018 (pm) upon starting the vehicle it ran rough. We tried to stop and restart but it did not correct the problem. On 5/23/18 (am) the vehicle started properly and was taken into to the dealer to diagnose the problem. On each occasion noted above the display screen prompts with the drivetrain malfunction message, but checking the on-board vehicle status all systems are "ok". Reduced power and/or complete loss of power in a critical situation could prove to be disastrous. Considering the number of complaints and potential risk the factory should elevate this complaint to a recall status before someone is seriously hurt (if that hasn't already happened).

See all problems of the 2013 BMW 650 🔎.

The contact owns a 2013 BMW 650i. The contact stated that while driving at 75 mph, there was a sudden vibration and the vehicle stalled without warning. The contact turned the vehicle off and restarted it to correct the failure. The vehicle was taken to tom bush BMW of orange park, located in jacksonville florida where the dealer performed a series of repairs on the vehicle such as the replacement of the spark plugs, the coils, the fuel injectors, the turbos and the power steering but the failure recurred. The cause of the failure was determined. The manufacturer was made aware of the failure. The failure mileage was 8,000.