Buick Regal owners have reported 3 problems related to underbody shield (under the structure category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Buick Regal based on all problems reported for the Regal.
We purchased this vehicle on 7 March 2012 and shortly afterwards I was checking it over and saw that the back of the headliner was hanging down about an inch or so. I took it into the the garage where I purchased the car and they had their repair person
check it out. They first tried to use double sided sticky tape and it did not work so they went to the head office of Buick to try to solve the problem. On 10 April I took the car back in and their fix was to stick small magnets to the roof and also to the headliner and then snap the magnets together. I don't know how many
magnets they used but the headliner is looking ok for now. I don't know how long this fix will last or if the headliner should have been replaced. Guess we will need to
wait and see.
See
all problems of the 2012 Buick Regal
🔎.
During routine maintenance discovered that the front rhs steering spindle to tie-rod attachment lug had cracked through one side of the lug. Spindle is fabricated from cast aluminum. Fatigue crack initiation from inclusion or potential casting defect was apparent before failure. Part number and photographs of the cracked surface are available.
See
all problems of the 2001 Buick Regal
🔎.
: the contact stated without warning the brake light illuminated. The vehicle was taken to an independent repair shop, where it was determined the entire under side of the vehicle was rusted. The vehicle was located in a salt belt state. The manufacturer was alerted.
See
all problems of the 1998 Buick Regal
🔎.
Problem Category | Number of Problems |
---|---|
Body problems | |
Structure problems | |
Paint problems | |
Underbody Shield problems | |
Frame And Members problems | |
Door problems | |
Door Hinge problems | |
Bumper problems | |
Frame Rust problems | |
Trunk Lid problems |