Two problems related to front suspension hub have been reported for the 2010 Cadillac SRX. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2010 Cadillac SRX based on all problems reported for the 2010 SRX.
I took my 2010 Srx into dealership due to a loud roaring noise and vibration in the vehicle at 50-60 mph. Dealership advised that tires needed to be replaced and vehicle aligned. Tires had less than 30,000 miles on them. All tires were replaced and vehicle aligned ($1000. 00+). Approximately 2 - 3 weeks later, I noticed a loss of power in the vehicle when trying to accelerate. Additionally, while stopped at a stop sign or light, vehicle sputtered and shook like it was going to die. This happened on several different occasions. Stability trac light come on during this time but then went out. 05. 01. 15, the vehicle completely lost all power to accelerate over 40 mph and has an awful roaring noise. 05. 05. 15, the vehicle was towed to the dealership & is currently there. Received call from dealership that the wheel hub bearings need to be replaced @ $1,100. 00+. I am not happy with this solution & do not believe is will fix the current issues with my vehicle, as I should not be having a bearing issue @ 70k miles. I now believe that something more was wrong to have caused my tires to have worn so quickly and poorly. Further, there is moisture buildup in both of my headlamps that I predict will cause problems after reading previous consumer complaints without gms acknowledgement.
At approximately 52,000 miles car developed a roar in front. I have been told that the front wheel hub assembly needs to be replaced. If this were to go on and not be replaced an accident could result from wheel bearing over heating or breaking off and causing accident.