Three problems related to hazard flashing warning light unit have been reported for the 2000 Chevrolet Impala. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2000 Chevrolet Impala based on all problems reported for the 2000 Impala.
Turn signals stop working intermittently. It probably happened 1 out of 10 times. The dealership said the unit needed to be replaced. They start working again if the hazard lights are turned on and then off. Dealership said the unit needed to be replaced. Part $74. 00 including labor $220. 00. No action has been taken.
The turn signals and hazard lights on my 2000 Impala do not work all the time. The problem has been getting progressively worse. The turn signals may work about 40% of the time. When they do work they may just quit w/o warning. This is a serious safety concern that needs to be address. When the problem first started to occur, I could turn on the hazards and this would jump start the blinkers and they would work for a while. This no longer works, both the hazards and the turn signals are intermittent. I am not the only Impala owner to experience this problem. This appear to be a wide spread defect with the Impalas. This problem is similar to the following existing vehicle recall for the 2000 Chevrolet malibu. . . Campaign number: 03v327000 date: 2003-Aug-28 . Why was this considered a great enough safety hazard to warrant a recall on the malibu but not on the Impala. Please investigate this is a serious hazard and needs to be recalled. Model year 2000 make: chevy model: Impala eng: 3. 4 v6.
No events leading up to the failure. Hazard lights sometimes stop working along with the turn signals pressing the hazard light switch will sometimes correct the issue.