Brake Abs Warning Light problems of the 2012 Chevrolet Impala

Clunking , grinding noise service stabilitrak, service abs lights come on lose power when reversing or making a left turn. After much research there seems to be a problem with the wiring harness going to the sensors in the wheels. Msny people are having this very same problem across many years of this vehicle. People are spending money unesacerally on parts such as wheel hubs and bearings without fixing said problem. Many people are also reporting cars turning off as a result of this.

When I start driving on local street each morning, I make a left turn, the car makes a loud grinding noise and my service traction control, service brake assist, & abs light all come on. They also go on & off when I go over speed bumps make a loud grinding noise. The traction control symbol will come on and I will be stuck trying to accelerate. This is very dangerous as I have almost been hit from behind a few times due to not being able to accelerate in a timely fashion. I have gone on chevy Impala forums looking for other drivers who may have experienced this are there are a good number of them. It seems to be an electrical problem. I finally took it to a mechanic and they could not reproduce the problem. It still happens.

Ttl-the contact owns a 2012 Chevrolet Impala. The contact stated that while attempting to move forward from a stop sign, the accelerator pedal was depressed but the vehicle failed to move forward as the brakes independently engaged. The abs warning light illuminated. The failure recurred on numerous occasions. The vehicle was taken to a dealer who diagnosed that a harness needed to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure. The failure mileage was 36,000. Oo.

The contact owns a 2012 Chevrolet Impala. Whenever the contact attempted to make a turn, especially a right turn, the vehicle seemed like it was sliding. The traction control and abs warning lights illuminated. The contact took the vehicle to a certified mechanic who was unable to diagnose the failure. The vehicle was not repaired. The manufacturer was not made aware of the failure. The approximate failure mileage was 78,823.

I was driving and after making a left turn, my service traction control, service brake assist, and abs light all popped on. It went on and off for many days as I would stop and then re-start the car. I finally took it to a chevy dealership and was told they tested the front abs connector and adjusted the timing. Lights and codes went off for about two weeks then popped back on upon making a left turn. In addition to the lights and codes, the car now make a loud grinding noise and the car stalls. I have been at a light in the middle of making a turn when the car will stall and not let me take off- the traction control symbol will come on and I will be stuck trying to accelerate. This is very dangerous as I have almost been hit from behind a few times due to not being able to accelerate in a timely fashion. I have gone on chevy Impala forums looking for other drivers who may have experienced this are there are a good number of them. It seems to be an electrical problem.

When driving after every attempt to make a left turn,my service traction control,service brake assist, & abs light all pop on. Since then it has went on and off for many days until it just finally stayed on permanently. Also message: "stabilitrak service and traction control , brake assist " finally took it to a chevy dealership in culver city,CA in may 2013 & was told they tested the front abs connector and traction and found nothing wrong and no code errors. Reset the sensors anyways and adjusted the timing. As soon as I drove out the dealer,same error messages and lights returned. Took car again to same dealer &wastold "I must have drove through water or oily surface and lights would go off after I drove 20 or so miles". Lights & errors did not go away. Returned to the same dealer again,this time again found no errors but they proceed to replace the tire sensors and reset the sensor id. Lights&codes went off for about a week then returned with a grinding noise when left turn, loose engine power &steering power, light &codes continue to stay on,& stalls for a few seconds when left turn. I have been at a light in the middle of making a turn when the car will stall & not let me take off. Brakes appear to lock up. Just missed a few car accidents due to stall. Has left me in dangerous situations as I have almost been hit head on & was hit from behind because I could not accelerate and got stuck on the turn. Cannot accelerate in a timely fashion is a huge problem. Because the dealer obviously could not resolve the issue had tire and brake expert shops look at the problem a few times. Also not finding the problem. Finally decided to just try &ignore it but after so many close calls of accidents& endagering my families life it is not acceptable for me to just deal with it anymore or to continue to spend money to try & find problem. Forums prove others have the same problem.