Three problems related to brake sensor have been reported for the 2006 Chevrolet Malibu. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2006 Chevrolet Malibu based on all problems reported for the 2006 Malibu.
2006 Chevrolet Malibu. Consumer writes in regards to torque sensor assembly; wiring harness to the bcm or mag beam and transmission shift cable that may fracture at any time. The consumer was informed, the parts were not available.
No physical incidents have taken place as of yet, however when asking about part being replace for my two recalls I get nothing but attitude and "I don't know" answers. My recalls are on the transmission shift cable, body control module, brake apply sensor and electronic stability control. I still make car payments, single mother with a toddler in the vehicle and all I get is an " I don't know" when our safety is in question. If I could afford a rental I would get one and keep the car parked, however a rental is like another car payment. . . . Where do I go from here?.
The contact owns a 2006 Chevrolet Malibu. The contact stated that the vehicle was experiencing transmission and bas sensor failure. The vehicle was not diagnosed or repaired. The manufacturer was made aware of the failure and stated that the vehicle was not included in NHTSA campaign number:14v252000 (electrical system , electronic stability control , exterior lighting , service brakes, hydraulic , vehicle speed control). The failure mileage was 80,000 and current mileage was 97,000.