11 problems related to brake fluid leak have been reported for the 2005 Chevrolet Silverado. The most recently reported issues are listed below.
Another driver notified us that our brake lights were not working. We stopped to check the situation and my wife applied the brakes as I checked the lights, which were not working. I then moved the truck about 50 yards and as I applied the brakes the pedal went to the floor. When I got out there was a puddle of brake fluid on the ground. The brake line had rusted out and when I applied pressure to stop, it gave out. I took the vehicle to a nearby dealer and they replaced all the brake lines due to the rust. Total cost $1050. This is a major safety issue. Luckily I was stopped when the failure occurred and no one was injured. If this had happened while moving in traffic the result could have been serious.
Traveling through intersection and making left hand turn to go in east direction. My vehicle's brakes catastrophically failed. The mechanic said that all(!) the brakes lines were rusted through and that my brake fluid leaked out. And now all of the brake lines will need to be replaced. Not one, not two - all! there was no warning light and no indication of any problems prior to this incident. The only thing worse than a gm product with a faulty ignition switch would seem to be a gm truck that can't stop!.
While stopped at a red light I noticed that I had to push the brake pedal all the way to the floor in order to keep the truck from rolling forward. When I got to a friends house I noticed that there was fluid leaking from some rusted brake lines located on the drivers side of the truck. As I pressed the brakes fluid was running out at an accelerated pace. I took the vehicle to the dealer and they said that all of the brake lines needed to be replaced due to rusting. There have been numerous complaints online about rusted brake lines on full size gm trucks. I contacted gm but they said that this is no recall for my vehicle and the repair is going to cost me nearly $1800. I bought the truck brand new in 2005 and its a little disturbing that something like that would fail that way where all of the brake lines were rusted only after 9. 5 years. If they would have broke suddenly they could have cause me to have an accident due to the fact that I wouldn't have been able to stop.
While driving at 55 mph, I applied the brakes to come to a stop. The brakes began to slow the truck then the pedal went clear to the floor and all braking action was lost. This caused me to strike the vehicle in front of me. Afterwards I observed brake fluid dripping from the lines forward of the rear axle and near the firewall area. I was very lucky to escape injury to myself and the other driver that I struck. My truck sustained extensive damage to the front end. I have not gotten estimates for repairs yet.
Driving down highway road when several deer ran in front of vehicle. Slammed on brakes and the pedal, after a few seconds, went to the floor. Noticed big puddle of fluid the next day under cab of truck. Started truck and had no brakes at all. Had the truck inspected by local repair shop and was informed that all of the brake lines were rusty beyond the point of repair. Had to have a whole new brake line kit installed.
Driving back to work from lunch on busy 4 lane highway, brake pedal went to floor. Narrowly avoided a collision at a red light. Put flashers on, lowered the gear selector, and used combo of minimal brake pedal and e brake to make it back to the parking lot at work. Upon inspection, large puddle of brake fluid on driver side near gas tank. Large leak in highly corroded brake line. All brake lines in similar condition and are currently being replaced in the shop. Transmission lines and fuel line are in similar highly corroded condition.
The brakes went out backing in to a driveway and all the fluid leaked on to the driveway and street. This could of been very serious if it happened on the highway coming home from picking up furniture. All the brake lines were rusted and had to be replaced?????? costly for us?.
The contact owns a 2005 Chevrolet Silverado. The contact stated that while driving approximately 25 mph, he depressed the brake pedal but the brakes were hesitant to respond. The contact inspected the vehicle and noticed corrosion and brake fluid leaking from the brake lines. The manufacturer was not made aware of the failure. The vehicle was not repaired. The approximate failure mileage was 130,000.
I was driving and applied the brakes for a stoplight when I felt a sudden lack of resistance in the petal. No warning lights were activated at all. I pulled over and pumped the brakes a few times and no pressure was regained. I got out of the truck and noticed a puddle of brake fluid towards the rear. Upon further inspection all od the brake lines were rusted badly and one had ruptured. No warning lights ever came on during the whole ordeal. The truck is under 8 years old and all of the brake lines need to be replaced. Luckily I was not in traffic or traveling faster when this occurred. I have never seen more rust on a newer vehicle in my life. Obviously the rust is beyond cosmetic and has proven to be a hazard.
Started truck placed foot on brake and pedal went to floor. Brake fluid leaked all over the ground. Had vehicle towed to repair shop. Brake line were totally rusted through. I drive the vehicle approximately once a week. It only has approximately 9700 miles on it. I am the only owner. The under carriage is also rusted. Luckily it happen in my driveway rather than on the road. Can provide a receipt for all new brakelines installed if needed.
Failure of braking system due to rusted brake lines, all lines need replacement. Upon attempting to stop the vehicle the brake pedal went to the floor, upon exiting the system was leaking brake fluid directly under the driver compartment.