Three problems related to brake hoses, lines/piping, and fittings have been reported for the 1996 Chrysler Town & Country. The most recently reported issues are listed below.
The contact owns a 1996 Chrysler town and country. The contact stated that the brakes failed while driving 15 mph. When the brakes where applied, the contact heard a pop and the brake pedal went completely to the floor. The vehicle was towed. The dealer stated that the brake hoses were not standard parts due to the modification of the brakes for medical handicap purposes. There were two holes in the hoses because the parts were not standard, which caused the brake failure. The current and failure mileages were 75,000.
Failure of both rear brake hydraulic lines causing sudden loss of brake fluid making emergency brake only operable stopping device. Saved old lines. Both lines appear to have rusted through. Mechanic believes problem is with design in how lines are routed above gas tank approximately two feet ahead of left rear wheel. The position of the lines allows road salt and other corrosives to be collected on the steel surface of the hydraulic lines, thus leading to their eminent failure. Please note low mileage of vehicle. Mechanic repaired vehicle by installing new lines, but routed them in a position less susceptible to corrosion. Failure was preceded by noticeable leaking of brake fluid on garage floor. Ultimate failure occurred when vehicle was brought in for inspection/repair. Lines burst when mechanic tested brakes by pressing hard on brake pedal while it was parked. Brake fluid spilled out all over service floor. Actual repair cost: $289. 02.
Consumer states that both brake lines rusted causing extened stopping. Ts.