Three problems related to adaptive equipment have been reported for the 2011 Chrysler Town & Country. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2011 Chrysler Town & Country based on all problems reported for the 2011 Town & Country.
The blind spot detection system stopped working. Upon further investigation, it was determined that both sensors in the rear quarter panels and 1 plug need to be replaced. The right rear sensor was completed corroded through and separated apart. The plug for this sensor is also melted from the corrosion. The left rear sensor has a large bulge in the plastic from over heating. I contacted the dealer and was told that this is a known problem but there is no recall. The estimate over the phone was $3,000. 00.
Blind spot detector stopped working at approximately 42,000 miles. Alarm came on saying "service blind spot system" and lights on both side view mirrors stays on all the time. The car just got out of warranty at 40,000 miles and they want to charge around $1,400 for rear module and around $800 for front module to fix the problem !! I think that's a scam !!! I purposely paid extra just for this safety feature and it doesn't work for no fault of ours !!! this is a safety problem because the car is large and the baby's car seat blocks the view out of the rear window !! while asking around I understand it's happened to quite a few people who own a town and country after they get out of their warranty ??? I see a pattern going on here !!! please look into this issue. Thank you for your time & gob bless !!!.
Vehicle back up camera too dim and not visible in bright sunlight.