Steering Rack And Pinion problems of the 1996 Ford Contour

I have had multiple problems w/ my 96 Ford Contour since I bought it 2/23/96. I have had it in for service multiple times, and I get told it's covered under warranty why worry about it. The srv. Mngr. At my dealer supposedly talked to a "tony" at Ford & told him to tell me as long as it's covered under warranty I shouldn't complain it is no money out of my pocket. That is unsatisfactory -I believe my car to be a defect in that years line of Contours & I would like something done about these problems. My car runs worse than any used car I have ever owned! all I ever wanted done was to rectify the situation,they could have easily replaced my car with one similiar to that year & model & I would have been happy. I really would like a response to this matter. I am to the point where I will contact a lawyer to seek help dealing with Ford & kennedy Ford , if I can not get a fair & aggreeable outcome to this situation. Thank you.

Excessive power steering fluid leak. The original rack and pinion assemply was replaced, due to leakage, with Ford parts. The replaced parts also leaked. After second replacement, the power steering hose leaked. At least two power steering hoses have been installed, both have leaked. All repairs attempts have been made by authorized Ford dealers under the manufacturers warranty.

Rack and pinion failed.

Problems with 1996 Ford Contour front brakes, transmission, fuse box, heater blower motor, electrical and steering and suspension. For the second time, the vehicle had problems with the brakes making a loud rubbing sound, the stabilizer bar was replaced and needs to be replaced again. The transmission was leaking, water was inside of the headlight seals, which made the lights very dim, the selector mode switch on the heater motor blower did not work properly, which made the heat not work at a 100%. The upper ball joints, rack and pinion and wheel bearing were all defective.