Engine Stall Problems of Ford Crown Victoria

The contact owns a 2005 Ford Crown Victoria. The contact stated while driving approximately 45 mph the wrench warning symbol illuminated and the engine stalled. Upon restarting the vehicle it failed to accelerate over 5 mph. The failure was repaired. The manufacturer was notified of the failure. The approximate failure mileage was 76,000. . . Updated 02-28-14 updated 03/19/2014.

See all problems of the 2005 Ford Crown Victoria 🔎.

The engine in my 2000 Crown Victoria stalled at a stop sign, and I lost the power steering and power brakes. The car turned into a tank and could not be controlled. It was extremely scary because I could have hit some innocent people which would have meant another lawsuit for Ford. I had to put one foot on the brake and one foot on the accelerator to get the car to an auto service center. At 38,938 miles, the car needed a new idle speed control motor, air filter, and mass air flow sensor. I believe that these parts were defective and wrote a letter to william clay Ford, the chairman of Ford motor company. While the car was still under warranty, the overdrive switch had to be replaced because the warning light would not go off. I felt that there should have been no charge, but the dealer charged me $200 for labor. I believe that this car is an ontario-built Monday morning lemon and will never buy another Ford automobile.

See all problems of the 2000 Ford Crown Victoria 🔎.

While driving lost all engine power, but engine never stalled. When stepping on gas pedal nothing happened. It happened before on a incline hill, and could not hold vehicle from rolling back. Then, took vehicle to dealer, and they did not find anything. Consumer believed problem was traction control.

See all problems of the 1999 Ford Crown Victoria 🔎.

While traveling engine would stall without any indication. Please provide further information.

See all problems of the 2001 Ford Crown Victoria 🔎.