Ford Focus owners have reported 2 problems related to camshaft position sensor (under the electrical system category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Ford Focus based on all problems reported for the Focus.
While driving down the expressway at 70mph my vehicle loss power entirely and stalled. I was nearly hit by the vehicle behind me and forced to pull over to the side of the road. The check engine light came on at the same time and indicated a camshaft position sensor, crankshaft position sensor, and ignition errors. I've owned this vehicle from the day it arrived at the dealership. The problem at fault has been previously identified by Ford in a TSB for the engine wiring harness chaffing on the intake manifold. Owners are not notified through mail on TSB's and this vehicle has been serviced by the dealer since the TSB was issued. I believe this should be a recall condition due to the accident potential this problem creates.
See
all problems of the 2013 Ford Focus
🔎.
Tl- the contact owns a 2013 Ford Focus. The contact stated that her vehicle stalled and slowed down when traveling at various speeds. The contact stated that the check engine waring light had illuminated on the vehicle. The contact took the vehicle to an independent mechanic where it was discovered that the vehicle had a defective camshaft sensor. Upon further investigation, the mechanic stated the engine wiring harness needed to be replaced . Upon investigation, the contact associated NHTSA campaign number: 15v813 (electrical system) with her defect. A VIN search was performed and showed that the contact's vehicle was not included in the recall. The contact spoke with planet Ford 20403 I-45, spring, TX 77388 (281) 719-3700 where they informed her that they are unaware of any recalls associated with the matter. The manufacturer was not notified of the failure. The vehicle had not been repaired. The failure mileage was unknown. Jo.