Engine Belts And Pulleys problems of the 2011 Ford Fusion

Three problems related to engine belts and pulleys have been reported for the 2011 Ford Fusion. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2011 Ford Fusion based on all problems reported for the 2011 Fusion.

1 Engine Belts And Pulleys problem

Failure Date: 05/02/2019

Tl- the contact owns a 2011 Ford Fusion. The contact stated that while driving at 30 mph, there was an abnormal clicking noise detected from the vehicle as the steering wheel seized. The vehicle was towed to the contacts resident. An independent mechanic came to take a look at the vehicle and informed the contact that the idle pulley bolt fractured and half of the bolt was stuck in the engine. The vehicle was not taken to a dealer for a diagnostic test or repairs. The manufacturer was not made aware of the failure. The failure mileage was approximately 189201. Dr.

2 Engine Belts And Pulleys problem

Failure Date: 05/28/2015

Car has extreme, loud, embarrassing belt area noise. In checking with two local Ford service departments I am told this happens all the time and is common. It's about a $700. 00 repair. Ford should take care of this problem for those affected which I am told are most that have been so unfortunate to have purchased a Fusion of the year 2011. This is ongoing from 0 to 70 mph.

3 Engine Belts And Pulleys problem

Failure Date: 01/22/2010

Vehicle not able to stop immediately. Brakes went to floor. January 22, 20120 pulley noise in engine continuously where air conditioning belt is placed.




Safety Ratings of Fusion Cars
Fuel Economy of Fusion Vehicles
Fusion Service Bulletins
Fusion Safety Recalls
Fusion Defect Investigations