Air Brake Abs Warning Light Problems of Ford Fusion

The contact's daughter owns a 2010 Ford Fusion. The contact stated while parking the vehicle, the wheel locked in place, and the vehicle failed to steer as intended. The vehicle was turned off. A short time later, the vehicle was restarted, and the abs and service track control warning lights illuminated. The vehicle was put in reverse(r) when the contact observed the steering wheel was stiff and did not steer as intended. The vehicle was not diagnosed or repaired. The manufacturer was notified of the failure. The failure mileage was unknown.

See all problems of the 2010 Ford Fusion 🔎.

The contact owns a 2010 Ford Fusion. The contact stated while the vehicle was parked, the abs warning light was illuminated and the message "service advancetrac" was displayed. The vehicle was taken to the dealer, where it was diagnosed that the wheel speed sensor had failed and needed to be replaced. The dealer replaced the wheel speed sensor and while attempting to reprogram the abs module with the new wheel speed sensor, the abs module failed to recognize the wheel speed sensor. The dealer informed the contact that the abs module needed to be replaced; however, the part was on back order. The manufacturer was notified of the failure, but no assistance was provided. The manufacturer referred the contact to the NHTSA hotline for assistance. The failure mileage was approximately 98,752.

The contact owns a 2017 Ford Fusion. The contact stated while driving at approximately 35 mph, the abs warning light illuminated and several other unknown warning lights flashed on and off. The contact had taken the vehicle to a parts seller who scanned the vehicle and found the following codes, u2002-96, c2008-92, and c2006-74. The vehicle had not been repaired. The manufacturer had not been informed of the failure. The failure mileage was approximately 105,000.

See all problems of the 2017 Ford Fusion 🔎.

The contact owns a 2010 Ford Fusion. The contact stated that while driving approximately 35 mph, the brake pedal was depressed however, the brakes failed to respond. Additionally, the contact stated that the brakes, abs, traction control, and check engine warning lights were illuminated. The contact veered to the side of the road and restarted the vehicle, but the failure persisted. The contact related the failure to NHTSA campaign number: 19v904000 (service brakes, hydraulic) however, the VIN was not included. The vehicle was not diagnosed or repaired. The manufacturer was notified of the failure. The failure mileage was 160,000.

The contact owns a 2010 Ford Fusion. The contact stated that the abs system was inoperable. The contact stated that there were no warning lights illuminated. The contact stated that the parking brake was needed to stop the vehicle. The contact also stated that the vehicle was leaking fuel. The contact stated that the fuel leak was evident whenever there was more than a half of fuel in the vehicle. The contact stated that after parking the vehicle overnight, there would be fuel on the ground underneath the vehicle. The vehicle was taken to the dealer and the contact was informed by the dealer that there was a glitch with his vehicle and there was nothing to be concerned about regarding the fuel pump. The contact stated that the dealer refused to service the vehicle. The manufacturer was notified of the failure and promised to call back however, the contact had not yet received the call back. The failure mileage was 260,000.

The contact owns a 2011 Ford Fusion. The contact stated that the brake pedal would depress to the floorboard as a brake system failure warning light would illuminate on the instrument panel. The contact took the vehicle to an independent mechanic who informed her of other model vehicles that had experienced the same failure; however, there were no recalls on her VIN associated with the failure. Neither the dealer nor the manufacturer was yet to be notified of the failure. The vehicle had yet to be repaired. The failure mileage was approximately 163,000.

See all problems of the 2011 Ford Fusion 🔎.

The contact owns a 2017 Ford Fusion. The contact stated that the vehicle would fail to start and required to be jumpstarted. The contact stated that the failure occurred intermittently. The contact stated while driving at various speeds, the vehicle stalled inadvertently. The contact stated that the failure mostly occurred while coming into a complete stop. The contact stated that on some occasions, the abs warning light would illuminate and the abs would make abnormal sounds prior to the failure, and on other occasions, the check engine warning light was illuminated and a message indicating that the vehicle was overheating was displayed. The contact stated that the vehicle was towed three times out of the five times it was taken to a Cadillac dealer and a Ford dealer. The dealers replaced the water pump, the alternator and an unknown part; however, the failure persisted. Additionally, the contact stated that the vehicle would lose electrical power while the battery was fully charged. The vehicle was not repaired. The contact later received recall notice of NHTSA campaign number: 23v162000 (service brakes, hydraulic) that he related to the failure. The manufacturer was not notified of the failure. The failure mileage was approximately 80,000.

The contact owns a 2009 Ford Fusion. The contact received notification of NHTSA campaign number: 19v904000 (service brakes, hydraulic) however, the part to do the recall repair was unavailable. The contact took the vehicle to chiefland Ford (916 n. Young blvd, chiefland, FL 32626) and informed the dealer that the abs warning light had illuminated on the instrument panel. Upon inspection of the vehicle, the mechanic informed him that the abs module needed to be replaced and that the replacement was not covered under recall. The manufacturer was made aware of the issue and called the service manager at the dealer. The manufacturer agreed with the dealer and confirmed that the abs module needed to be replaced. No additional assistance was provided. The approximate failure mileage was 12,000. VIN tool confirms parts not available.

See all problems of the 2009 Ford Fusion 🔎.

The contact owns a 2008 Ford Fusion. The contact stated while driving at an undisclosed speed, the contact depressed on the brake pedal however, the vehicle failed to stop in a reasonable time. The contact depressed the brake pedal all the way to the floorboard for the vehicle to stop. The contact stated that the abs warning light was illuminated. The failure reoccurred intermittently. The vehicle was taken to a local dealer who inspected the vehicle but could not duplicate or diagnosed the cause of failure. The vehicle was not repaired. The manufacturer was made aware of the failure. The failure mileage was approximately 75,000.

See all problems of the 2008 Ford Fusion 🔎.

The contact owns a 2009 Ford Fusion. The contact stated that while driving at various speeds, the vehicle experienced delayed brake responses while depressing the brake pedal. The abs warning light was illuminated. The contact then received notification of NHTSA campaign number: 19v904000 (service brakes, hydraulic) however, the part to do the recall repair was unavailable. The contact stated that the manufacturer exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The failure mileage was approximately 120,000. VIN tool confirms parts not available.