Air Brake Antilock Control Unit/module Problems of Ford Fusion

The contact owns a 2012 Ford Fusion. The contact stated that while driving at approximately 35 mph, he drove over a bump on a train track and was required to depress the brake pedal down to the floor board in order for the vehicle to come to a stop. No warning lights were illuminated. A local dealer was made aware of the failure and informed him they could not service vehicles 10 years or older. The vehicle was then taken to an independent mechanic, where it was diagnosed that the abs control module needed to be replaced. The contact referenced the failure to NHTSA campaign number: 19v904000 (service brakes, hydraulic) however, the VIN was not included in the recall. The vehicle was not repaired. The manufacturer was not made aware of the failure. The approximate failure mileage was 95,000.

See all problems of the 2012 Ford Fusion 🔎.

The contact owns a 2010 Ford Fusion. The contact stated while starting the vehicle, the abs, parking brake, and the traction control warning lights were illuminated. The contact also stated the brake pedal was soft and spongy and the contact had to depress the brake pedal to the floorboard to stop the vehicle. The vehicle was not drivable. The contact towed the vehicle to a local dealer, where it was diagnosed with needing the abs module to be replaced. The vehicle was not repaired. Upon investigation, the contact associated the failure with NHTSA campaign number: 19v904000 (service brakes, hydraulic) however, the VIN was not included. The manufacturer had not been informed of the failure. The failure mileage was approximately 92,000.

See all problems of the 2010 Ford Fusion 🔎.

The contact owns a 2012 Ford Fusion. The contact stated while driving 20 mph and depressing the brake pedal, the vehicle failed to stop within a reasonable time. The contact stated no warning light was illuminated. The contact stated he was able to stop the vehicle after pumping the brake pedal. The contact took the vehicle to the local dealer however, the mechanic was unable to duplicate the failure. The contact continued to experience the failure. The contact took the vehicle back to the local dealer, where it was diagnosed and the brake lines were flushed several times. The vehicle continued to experience the failure. The contact took the vehicle back for a third time and was informed that the rear and front brake calipers, the abs hydraulic control unit (hcu), and the brake master cylinder needed to be replaced. The vehicle was not repaired. The manufacturer had been informed of the failure. The failure mileage was approximately 95,000.

The contact owns a 2008 Ford Fusion. The contact stated the while her daughter was driving at various speeds, the brake pedal depressed to the floorboard however, the vehicle was slow to respond which extended the stopping distance. There were no warning lights illuminated. The contact received notification of NHTSA campaign number: 19v904000 (service brakes, hydraulic) however, the part to do the recall repair was unavailable. The vehicle was taken to malloy Ford charlottesville (2070 seminole trail, charlottesville, va 22901, (434) 977-7960) where it was confirmed that the part was not available. The vehicle was taken to madison Ford (2895 s. Seminole trail, madison, va 22727, (540) 948-6806) where the vehicle was diagnosed with a defective abs control module and abs unit, which needed to be replaced. The vehicle was not repaired. The vehicle was taken to an independent mechanic who performed a brake flush, replaced brake pads and rotors. The contact stated that the manufacturer exceeded a reasonable amount of time for the recall repair. The failure mileage was 89,000. The manufacturer was made aware of the issue. VIN tool confirms parts not available.

See all problems of the 2008 Ford Fusion 🔎.