Brake Hoses, Lines/piping, And Fittings Problems of GMC Canyon

GMC Canyon owners have reported 2 problems related to brake hoses, lines/piping, and fittings (under the service brakes category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of GMC Canyon based on all problems reported for the Canyon.

1 Brake Hoses, Lines/piping, And Fittings problem of the 2005 GMC Canyon

Failure Date: 04/15/2018

The brake lines and the entire frame is rusted out. There are big wholes in the frame. The garage wouldn't even put it on the lift, because it was so bad. Have replaced breaks and still the truck has break issues.

See all problems of the 2005 GMC Canyon 🔎.

2 Brake Hoses, Lines/piping, And Fittings problem of the 2009 GMC Canyon

Failure Date: 05/12/2009

The contact owns a 2009 GMC Canyon. While pulling into a parking space at 10 mph, the brake pedal extended to the floor when it was depressed. The contact believed that there was air in the brake line, and that the air should be bled from the hydraulic system. The mechanic stated that other vehicles were experiencing the same issue and bleeding the air out of the hydraulic braking system would not repair the failure. The mechanic further stated that the vehicle was designed to operate in that manner. Currently, the brakes continue to fail. The failure mileage was 50 and current mileage was 955. Updated 07/01/09 the consumer stated when the brake pedal was depressed below the gas pedal, the brake did not go all the way to the floor. The consumer stated on 6 occasions, when the brake was applied, his foot would also press the accelerator. Updated 07/06/09.

See all problems of the 2009 GMC Canyon 🔎.


Other Common Service Brakes related problems of GMC Canyon



Safety Ratings of Canyon Cars
Fuel Economy of Canyon Vehicles
Canyon Service Bulletins
Canyon Safety Recalls
Canyon Defect Investigations