Three problems related to car stall have been reported for the 2010 GMC Yukon. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2010 GMC Yukon based on all problems reported for the 2010 Yukon.
The contact owns a 2010 GMC Yukon denali. While driving 65 mph, the vehicle stalled without warning. The contact was able to restart the vehicle. The contact stated that the failure recurred twice. The vehicle was taken to an independent mechanic to be diagnosed. The contact was informed that the valve lifters were defective and needed to be replaced. The vehicle was repaired; however, the failure recurred. The local dealer was not contacted. The manufacturer was notified of the failure. The approximate failure mileage was 142,743.
The contact owns a 2010 GMC Yukon denali xl. While driving approximately 45 mph, all of the instrument panel indicators began to illuminate. The contact stated that the check engine indicator remained illuminated. In addition, the service stability track control indicated off. The contact also stated that the vehicle stalled but was able to restart the vehicle. The failure was recurring. The vehicle was taken to the dealer where ti was diagnosed that the spark plug failed. The vehicle was not repaired. The manufacturer was notified of the failure. The approximate failure mileage was 101,000.
The contact owns a 2010 GMC Yukon. The contact stated that while driving 5 mph, the vehicle stalled without warning. The contact took the vehicle to the dealer for diagnostic testing where the contact was advised that the ecm was defective. The dealer replaced the ecm but the repair did not remedy the issue. The manufacturer sent the contact a special order repair for the throttle body due to reduced engine power. The contact called the manufacturer regarding the stalling issue however, the manufacturer refused to accept that the vehicle was stalling. The dealer replaced the throttle control. The failure mileage was 30,000.