Wheel Cover/hubcaps Problems of GMC Yukon

2005 GMC Yukon. Consumer writes in regards to various electronic problems including service air bag indicator. The consumer stated he experienced chronic problems with speedometer, starting problems, wheel hub and traction control sensor. Also, the transfer case was replaced.

See all problems of the 2005 GMC Yukon 🔎.

The contact owns a 2004 GMC Yukon xl. The drive- front wheel hub made a rattling noise when driving. Also the traction control and abs lights were illuminated on the instrument control panel. . He called both the dealership and the manufacturer in reference to recall number 07e106000 (wheels:cap/cover/hub). He was advised that his vehicle identification number was excluded from the recall. No repairs were made. The current mileage was approximately 80,000. The failure mileage was approximately 79,200.

See all problems of the 2004 GMC Yukon 🔎.

The contact owns a 2002 GMC Yukon. While driving 10 mph, the abs activated and the contact heard a fluttering noise. The failure also occurred when the brake pedal was depressed. The dealer stated that the wheel hubs needed to be replaced and informed the contact that her VIN was not included in NHTSA campaign id number 07e106000 (wheels:cap/cover/hub). The purchase date was unknown. The current mileage was 30,880 and failure mileage was 23,700.

See all problems of the 2002 GMC Yukon 🔎.

I am the original owner of a 2002 Yukon xl truck. I purchased the truck two years ago from a GMC dealer in macon GA. I noticed the steering column felt loose and made unusual noise when going over bumps and when turning. I took the truck into a local dealer under a warranty call. The service department repaired/adjusted the steering system and the vehicle drove fine for approximately 6 months. However the same noise came back and the trucks anti lock brake light and traction assistance lights came on. I took the truck to a repair shop to have it looked. The shops owner discovered one of the front hub assemblies had failed and needed to be replaced. The owner told me the hubs bearings had completely failed and there was a strong possibility the wheel could have separated from the vehicle. This truck is 2 years old and only has 50,000 miles on it.