Rear Suspension Shock Absorber Problems of Jeep Cherokee

Monroe shock absorber, model 550017; unit code p154h1 after two years of light service in California the unit was removed to install a load supporting model 58914. Unit 550017 was functioning well with no visible signs of damage / malfunction. This shock absorber exploded upon removal from the lower mount. . The lower section was driven to the floor being propelled by compressed gas and oil. The upper section fell harmlessly to floor. There are no injuries or damages associated but that is a matter of fortune, not design. The retention mechanism has no safety design feature to prevent this. This should not be the case with gas charged shocks. Information supplied with the units make no mention of this possible failure.

See all problems of the 2000 Jeep Cherokee 🔎.

Tl-the contact owns a 2014 Jeep Cherokee. The contact stated that while driving at 35 mph, the vehicle would vibrate. The contact received notification of NHTSA campaign number: awaiting# (rear suspension shock absorber) however, the part to do the repair was not available. The contact stated that the manufacturer exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the failure. The failure mileage was 8,500. Aw.

See all problems of the 2014 Jeep Cherokee 🔎.

Fog light shortage from the interior switch, rear left shock squeaks non stop at low speeds, loss of electrical power when a/c is on (hot or cold), grinding noise coming from rear axle when coming out of first gear, noisy dashboard when road is bumpy, small signs of rust starting to appear on exterior, font passenger window does not go up if put down by passenger, driver side window making noise.

See all problems of the 1999 Jeep Cherokee 🔎.