Three problems related to transmission not go into gear have been reported for the 2006 Jeep Commander. The most recently reported issues are listed below.
The contact owns a 2006 Jeep Commander. The contact stated that the esp/ bas warning light illuminated intermittently. In addition, the four wheel drive option failed and the vehicle failed to shift gears. The contact stated that the failures occurred after the vehicle was serviced under NHTSA campaign number: 13v175000 (electrical system , power train). The vehicle was not diagnosed or repaired. The manufacturer was notified of the failure. The approximate failure mileage was 150,000. The VIN was not available.
The contact owns a 2006 Jeep Commander. In may of 2006, the contact began experiencing issues with the transmission and electrical system in his vehicle. The vehicle would not change gears and the instrument panel lights were constantly illuminated. He took the vehicle to the dealer three times and they reprogrammed the computer, which allowed the vehicle to perform normally for a while. On April 25, 2008, the vehicle shut off and remained locked in third gear while driving 10 mph. The contact was able to drive the vehicle to his residence. The dealer stated that there was no recall. Previously, the contact took the vehicle to a repair shop to be diagnosed and was informed that the control module failed; however, the dealer continues to state that there is no failure. The failure mileage was 18,166 and current mileage was 85,000.
Doors leak rust on the hinges now, knocking sound in the engine,be driving down the road all of sudden the Jeep will not shift all gears are lit up have to stop shut down for 5 to 10 min. Then will be ok been in the shop 10 times told I had electric lifters put a piece of weather strip in the door to fix leak they say rust is normal reset the transmission and a leak on it replaced motors to power windows still don't work right.