Two problems related to frame and members have been reported for the 2000 Jeep Grand Cherokee. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2000 Jeep Grand Cherokee based on all problems reported for the 2000 Grand Cherokee.
2000 Jeep Grand Cherokee - heater core leakage led us to take up carpet - both driver's side and passenger side holes in the frame which hold the seats down to the body, were rusted through. Cause - water trap (design flaw) in design of the unibody, and no undercoating to help prevent such occurrence. Frame metal is approx. 1/8th inch thick. Areas affected were cut out and new metal welded in (by private party - not dealer. I do have the pieces which were cut out. ) should there have been a collision, the seats would have broken loose from the frame and serious injuries would have occurred. Other comments made on this same vehicle, to include ours, relate how the actual seat frame breaks. Metal found when this occurred is weakened - not re-enforced to prevent breakage.
Consumer stated that the driver seat became loose which it will allowed it to rock back and forward. Dealer was contacted and stated that the frame on the seat had broken and it was replaced . Ts.
| Door problems | |
| Structure problems | |
| Body problems | |
| Hood Hinge problems | |
| Hood problems | |
| Frame And Members problems | |
| Tailgate problems | |
| Frame Rust problems |