Three problems related to front air bag sensor control have been reported for the 2007 Jeep Wrangler. The most recently reported issues are listed below.
Taka airbags, tipm fuse box. Completely disables the vehicle. They have known about and have been running this part in many Chrysler Dodge Jeep vehicles since 1995. My car is a 2007. It reckon havock on the whole electrical system. The dealer milks all of your 260 somthing sensors before replacing the tipm, totally integrated power module. And the sway bar disconnect is prone to water damage and shorting out because they let water in the assembly and short out then they charge you 1400 dollars for a new one. When it is just the actuator. A manual override is only 89. 00. All of these problems are from the can buse c. 90 %of this vehicle problems are from this can buse c. But no recall on the tipm, sway bar actuator, or can buse c communication. This whole electrical system should be a recall. It is garbage. Over complicated and under nesasary! driving done the freeway and the whole dashboard lights up I pulled over turned car off and then would not turn back on. Goes in to a limp mode. I was worried that it would shut off or worse cause an accident or leave me stranded in the freeway! the airbag recall could set the airbag of wile driving causing you to crash.
Faulty clockspring causing multiple lights to be illuminated on my dash. Also have to have the steering angles sensor replaced with the clock spring.
My airbag sensor light stays on.