Engine And Engine Cooling Related Problems of the 2015 Jeep Wrangler

Table 1 shows 14 common engine and engine cooling related problems of the 2015 Jeep Wrangler. The number one most common problem is related to the engine and engine cooling (80 problems). The second most common problem is related to the engine oil leaking (eleven problems).

Table 1. Engine And Engine Cooling related problems of Jeep Wrangler

Problem Category	Number of Problems
Engine And Engine Cooling problems	80
Engine Oil Leaking problems	11
Radiator problems	9
Engine Clicking And Tapping Noises problems	6
Check Engine Light On problems	5
Engine Exhaust System problems	3
Engine Shut Off Without Warning problems	3
Car Stall problems	2
Engine Noise problems	2
Engine Burning Oil problems	1
Gas Recirculation Valve (egr Valve) problems	1
Engine Knocking Noise problems	1
Coolant Leaking problems	1
Manifold/header/muffler/tail Pipe problems	1

Recently reported Engine And Engine Cooling problems of the 2015 Jeep Wrangler

The Engine And Engine Cooling problem

Abs module error: c2200 causes Jeep to go into limp mode when accelerator is pushed hard. Near miss on collision, lack of abs causes skidding and possible loss of control. Read details...

The Engine Oil Leaking problem

Failure of combined oil filter / cooler housing resulting in abrupt loss of engine oil and resulting in small fire following exhaust system saturation from leaking oil Read details...

The Radiator problem

Twice, end of may 2019 and February of 2020 I had scheduled oil changes done at same dealer. By the end of those days, Jeep would not run, check engine light blinking and would barely start, not run. Both times towed back to dealership, both times under warranty. Read details...

Engine And Engine Cooling related problems in other Jeep Wrangler model year vehicles:

Switch Make:

Switch Model:

☘ Wrangler Service Bulletins

⚑ Wrangler Safety Recalls

☤ Wrangler Defect Investigations