Crankshaft Position Sensor Problems of Kia Motor Forte

Engine issues! this engine needs to be recalled for safety reasons and possible lemon. My car has only 106,890 miles on it. The engine started making a tapping noise. Then I started to have a loss of power when accelerating or going up hill. Had the codes read and it said the crankshaft position sensor. Replaced that. Then it started to idle rough. Had code read again. It said map sensor and number 2 cylinder misfire. Replaced plugs, coils, and map sensor. Now it won't start. It has no spark. Now it is showing codes for map sensor again. Number 2 cylinder misfire, throttle actuator control sensor and the power train control module. At just over 100,000 miles this should not be happening. Other model cars with the same 2. 0 engine have been recalled. The 2. 0 engine needs to also be recalled in the 2011 kia Forte koup ex. I'm not the only owner of this model car that has had multiple issues and or total engine failure.

See all problems of the 2011 Kia Motor Forte 🔎.

Hello, I am currently having issues with my 2010 kia Forte. The vehicle has been struggling to accelerate and soon eventually began to feel as if it were going to stall out all together every time I stepped on the gas. The check engine light came on and after diagnosing the code, it read p0336 (crankshaft position sensor a circuit range/performance). After some research I found that apparently there is a recall on these engines for what appears to be the same issue I am currently having. I looked up my vehicles VIN on this website and was notified that there is not currently an open recall even though I had just read that hundreds of thousands of vehicles of the same make and engine type (theta 2) were being recalled for crankshaft issues. Would like to have my car checked out via recall measures. The safety of my family is in question due to these known issues.

See all problems of the 2010 Kia Motor Forte 🔎.