Steering Tie Rod Assembly Problems of Mazda MAZDA6

Mazda MAZDA6 owners have reported 2 problems related to steering tie rod assembly (under the steering category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Mazda MAZDA6 based on all problems reported for the MAZDA6.

1 Steering Tie Rod Assembly problem of the 2009 Mazda MAZDA6

Failure Date: 05/28/2014

The contact owns a 2009 Mazda Mazda6. The contact stated that while traveling 65 mph, the low tire pressure warning light illuminated and the vehicle veered to the left. As a result, the tire blew. The vehicle was taken to a private mechanic where it was diagnosed that the tie rod valves needed to be replaced. The manufacturer was not notified of the failure. The vehicle was repaired. The failure and current mileage was 88,000.

See all problems of the 2009 Mazda MAZDA6 🔎.

2 Steering Tie Rod Assembly problem of the 2003 Mazda MAZDA6

Failure Date: 06/09/2013

Tl- the contact owns a 2003 Mazda Mazda6. The contact stated that while driving approximately 50 mph the vehicle stalled. The contact stated blue smoke was emitting from the tail pipe and the check engine light illuminated. The vehicle was taken to an independent mechanic for diagnosis. The mechanic stated the catalytic converters were clogged and would have to be replaced. Additionally, the mechanic stated the front passenger's side tie rod was loose and could fracture. The vehicle was not repaired. The VIN was not available. The approximate failure mileage was 122,000. Da.

See all problems of the 2003 Mazda MAZDA6 🔎.


Other Common Steering related problems of Mazda MAZDA6



Safety Ratings of MAZDA6 Cars
MAZDA6 Service Bulletins
MAZDA6 Safety Recalls
MAZDA6 Defect Investigations