Brake Disc Caliper Problems of Mitsubishi Endeavor

Mitsubishi Endeavor owners have reported 3 problems related to brake disc caliper (under the service brakes category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Mitsubishi Endeavor based on all problems reported for the Endeavor.

1 Brake Disc Caliper problem of the 2005 Mitsubishi Endeavor

Failure Date: 10/10/2011

The contact owns a 2005 Mitsubishi Endeavor. The contact was driving 10 mph when the brakes were depressed but the vehicle failed to stop. The emergency brake was deployed in order to stop the vehicle. The contact also mentioned the vehicle caliper was detached under the vehicle. The vehicle was taken to a private mechanic where the mechanic confirmed that the caliper and front brakes needed to be replaced. The manufacturer was contacted and they confirmed that the VIN did not qualify for repairs under NHTSA campaign id number: 06v068000 (service brakes, hydraulic: foundation components:disc:caliper). The vehicle was repaired. The failure mileage was 80,000 and the current mileage was 82,000.

See all problems of the 2005 Mitsubishi Endeavor 🔎.

2 Brake Disc Caliper problem of the 2005 Mitsubishi Endeavor

Failure Date: 07/19/2011

The contact owns a 2005 Mitsubishi Endeavor. The contact was driving 35 mph when the front brake calibers detached forcing an emergency stop. The vehicle was unable to be driven and was towed. The vehicle was serviced by a private mechanic who confirmed the failure. The vehicle was repaired by replacing the calibers and installing new brakes. The manufacturer was contacted who advised that the VIN did not qualify for repairs under NHTSA campaign id number: 06v068000 (service brakes, hydraulic:foundation components:disc:caliper). The failure mileage was 130,000 and the current mileage was 131,000.

3 Brake Disc Caliper problem of the 2004 Mitsubishi Endeavor

Failure Date: 07/01/2006

Replacing front and back pads every 5k - 8k miles. Replaced front and back rotors twice in 100k. Replacing front and back calipers one in 100k. Replacing calipers pins both front and back every time pads were replaced. Turns out because of poor engineering and design the calipers pins collect moisture and corrode causing them to freeze up and not allowing calipers to perform properly, in turn the calipers are restricted , ruining the rotors and eat up the pads.

See all problems of the 2004 Mitsubishi Endeavor 🔎.


Other Common Service Brakes related problems of Mitsubishi Endeavor



Safety Ratings of Endeavor Cars
Fuel Economy of Endeavor Vehicles
Endeavor Service Bulletins
Endeavor Safety Recalls
Endeavor Defect Investigations