Gas Recirculation Valve (egr Valve) Problems of Porsche 911

Porsche 911 owners have reported 1 problem related to gas recirculation valve (egr valve) (under the engine and engine cooling category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Porsche 911 based on all problems reported for the 911.

1 Gas Recirculation Valve (egr Valve) problem of the 2004 Porsche 911

Failure Date: 10/11/2013

The m96 motor supplied with this vehicle line has had the following problems. Engine block leaks the block is porous. Resleeved cylinders were maker fix ,the sleeves moved causing engine destruction. A main crankshaft bearing was designed out. Allowing the crankshaft to move frt to back and with gravity causing a failure of the rear main seal could not fix if crank had moved more than a few degrees from orig spec. Primary problem ims( intermediate shaft) failure. Result, complete destruction of motor. No fix from manufacture. After market only supply. Over ten thousand after market repairs done. Conservative apx cost $,3000 I have much more evidence.

See all problems of the 2004 Porsche 911 🔎.


Other Common Engine And Engine Cooling related problems of Porsche 911



Fuel Economy of 911 Vehicles
911 Service Bulletins
911 Safety Recalls
911 Defect Investigations