Power Train Problems of Suzuki Verona

Transmission jerking when shifting to 2nd to 3rd gear codes are p0783, p0741, p0700.

See all problems of the 2006 Suzuki Verona 🔎.

The contact owns a 2005 Suzuki Verona. The contact stated that while driving at various speeds, the vehicle hesitated when shifting. Also, the contact stated that the vehicle failed to accelerate. The vehicle was taken to the dealer. The technician diagnosed that the transmission needed to be replaced. The vehicle was repaired however, the failure recurred. The vehicle transmission was replaced 2 other additional times but the failure persisted. The failure mileage was 90,000.

See all problems of the 2005 Suzuki Verona 🔎.

I am going to list the problems that I have with my 04 Suzuki Verona ex. 1. Turn signals do not cancel out (usually while turning left) 2. Steering wheel audio controls, volume acts like a mute, seal acts like mode, mode turns off radio and the cd player sticks. 3. Heated seats turn on and off by itself. You need to push the button a few times before it will activate. 4. Cruise control will disengage by itself (this is intermittent) 5. Head lights burn out about every 3 - 4 months. 6. One abs sensor went out around 30k miles and the second went out about 80k miles. 7. Right now I have cylinders 5 & 6 that are misfiring on the vehicle that need to be replaced. The amount to fix this problem is more then my car is worth. We are 3k miles over warranty and so far Suzuki will not help.

See all problems of the 2004 Suzuki Verona 🔎.

2004 Suzuki Verona problems with jolting after being stopped. Consumer states that when the accelerator was depressed the engine would not register it right away until about 3 seconds or so then the vehicle would lurch forward. The consumer also stated the check engine light would illuminate as well. While driving, suddenly the vehicle started dropping speed, the engine was running; there was simply no connection between the running engine and the gas pedal. Because the consumer had the cruise control set, the gas pedal lodged into the floor board trying to maintain cruising speed. Several components were replaced to try and resolve the problem such as the transmission, head gaskets, pcv, fuel pressure regulator, fuel pump, catalytic converter, and O2 sensor. The abs light illumined in October 2006. In March 2007 a new abs module was installed.